2A, 1.3MHz Step-Up Converter

General Description The MP1527 is a 2A, fixed frequency step-up converter in a tiny 16 lead QFN package. The high 1.3MHz switching frequency allows for smaller external components producing a compact solution for medium-to-high current step-up, flyback, and SEPIC applications. Features

文件：178.91 Kbytes 页数：4 Pages

MPS

美国芯源

2A, 1.3MHz Step-Up Converter

General Description The MP1527 is a 2A, fixed frequency step-up converter in a tiny 16 lead QFN package. The high 1.3MHz switching frequency allows for smaller external components producing a compact solution for medium-to-high current step-up, flyback, and SEPIC applications. Features

文件：272.81 Kbytes 页数：14 Pages

MPS

美国芯源

6 White LEDs, 20mA Precision WLED Driver Evaluation Board

DESCRIPTION The MP1523 is a 5-pin SOT23 step-up converter designed for driving up to six (6) series white LEDs from a single-cell Lithium Ion battery. The MP1523 uses a current limited, variable frequency architecture to regulate the LED current, which is measured through an external current se

文件：128.33 Kbytes 页数：4 Pages

MPS

美国芯源

Precision 6-Lamp White LED Driver

DESCRIPTION The MP1523 is a 5-pin SOT23 step-up converter designed for driving up to six (6) series white LEDs from a single-cell Lithium Ion battery. The MP1523 uses a current limited, variable frequency architecture to regulate the LED current, which is measured through an external current se

文件：140.67 Kbytes 页数：7 Pages

MPS

美国芯源

Cold Cathode Fluorescent Lamp Driver

DESCRIPTION The MP1010B is a power solution IC that offers a true complete solution for driving a Cold Cathode Fluorescent Lamps (CCFL). This Power IC converts unregulated DC voltage to a nearly pure sine wave required to ignite and operate the CCFL. Based on proprietary power topology and cont

文件：35.01 Kbytes 页数：1 Pages

MPS

美国芯源

High Current Integrated Half Bridge Driver

DESCRIPTION The MP8040 is a general purpose, high frequency half bridge power driver capable of driving a 9A load. The devices integrates both top and bottom N-Channel MOSFET power switches and is fully protected from both sourcing and sinking current by a preset cycle-by-cycle current limit. It

文件：249.66 Kbytes 页数：8 Pages

MPS

美国芯源

Full Bridge or Single Ended Audio Amplifier

General Description The EV0041 is an evaluation board designed to demonstrate the capabilities of MPS’ MP8040. It can be configured as a stereo single ended amplifier (EV0041A) or a full bridge mono amplifier (EV0041B). Features ■ +/- 9A Peak Current Output ■ +/- 4.25A Continuous Current Outpu

文件：316.18 Kbytes 页数：5 Pages

MPS

美国芯源

1x, 1.5x, 2x High Efficiency Charge Pump 4 White LED Driver Evaluation Board

GENERAL DESCRIPTION The EV0042 is an evaluation board for the MP1519, a fully automatic driver for powering four white LEDs, with up to 4V forward voltage, from a single Li-Ion or three NiMH cells. The driver performs all of the sensing and control to run the LEDs at an optimum charge pump ratio

文件：185.33 Kbytes 页数：3 Pages

MPS

美国芯源

1x, 1.5x, 2x High Efficiency Charge Pump 4 White LED Driver

DESCRIPTION The MP1519 is a fully automatic driver for powering four white LEDs, with up to 4V forward voltage, from a single Li-Ion or three NiMH cells. The driver performs all of the sensing and control to run the LEDs at an optimum charge pump ratio for efficiency without an expensive inductor

文件：211.75 Kbytes 页数：8 Pages

MPS

美国芯源

3A, 25V, 1.1MHz Step-Up Converter for WLED Applications

DESCRIPTION The EV1517 is the evaluation board used to demonstrate the white LED driver capabilities of the MP1517. The low 0.7V feedback voltage offers higher efficiency in white LED driver applications including cell phone camera flash. Soft-start, cycle-by-cycle current limiting and input unde

文件：198.13 Kbytes 页数：3 Pages

MPS

美国芯源