Arduino Nano 328 (SKU: DFR0010)

 Microcontroller Atmel ATmega168 or ATmega328  Operating Voltage (logic level) 5 V  Input Voltage (recommended) 7-12 V  Input Voltage (limits) 6-20 V  Digital I/O Pins 14 (of which 6 provide PWM output)  Analog Input Pins 8  DC Current per I/O Pin 40 mA  Flash Memory 16 KB (ATmega16

文件：102.76 Kbytes 页数：4 Pages

DFROBOT

上海智位机器人股份有限公司

IIC to GPIO Shield V2.0 SKU: DFR0013

 Module power supply: +5 V  16 Digital I/O port comes with internal pull-up  Can be set to eight addresses (address range of 0x20 ~ 0x27)  8 modules simultaneously in parallel (IIC bus need to pull together)  Module Size: 56x53mm (2.21x2.08 in)

文件：257.38 Kbytes 页数：5 Pages

DFROBOT

上海智位机器人股份有限公司

Xbee Shield For Arduino (no Xbee) (SKU:DFR0015)

 Direct support Arduino UNO, Arduino Duelimanove, DFRduino UNO  Compatible with all Xbee interface devices:  Xbee 1mw / 2mw  Xbee Pro  Xbee 2.5 series  Bluetooth Bee  Wireless Programming Module  Jumper: Switch communication connection with the PC and the Arduino Xbee

文件：203.47 Kbytes 页数：3 Pages

DFROBOT

上海智位机器人股份有限公司

Mega Prototyping Shield for Arduino Mega Due SKU:DFR0016

 Reset button up top  Lots of GND and +5V rails  DIP prototyping area makes it easy to add more chips

文件：111.23 Kbytes 页数：1 Pages

DFROBOT

上海智位机器人股份有限公司

Relay Module (Arduino Compatible) (SKU: DFR0017)

 Type: Digital  Single relay board  Rated through-current: 10A (NO) 5A (NC)  Maximum switching voltage: 150VAC 24VDC  Digital interface  Control signal: TTL level  Rated load: 8A 150VAC (NO) 10A 24VDC (NO), 5A 250VAC (NO/NC) 5A 24VDC (NO/NC)  Maximum switching power: AC1200VA DC240W

文件：231.87 Kbytes 页数：3 Pages

DFROBOT

上海智位机器人股份有限公司

Gravity: Digital Push Button (Green)

 Wide voltage range from 3.3V to 5V  Standard assembling structure (two 3mm diameter holes with multiple of 5mm as distance from center)  Easily recognitive interfaces of sensors (A for analog and D for digital)  Icons to simplely illustrate sensor function  High quality connector  Imme

文件：53.82 Kbytes 页数：2 Pages

DFROBOT

上海智位机器人股份有限公司

Gravity: Digital Push Button (Red)-DFRobot

FEATURES  Wide voltage range from 3.3V to 5V  Standard assembling structure (two 3mm diameter holes with multiple of 5mm as distance from center)  Easily recognitive interfaces of sensors (A for analog and D for digital)  Icons to simplely illustrate sensor function  High quality connect

文件：53.8 Kbytes 页数：2 Pages

DFROBOT

上海智位机器人股份有限公司

Gravity: Digital Capacitive Touch Sensor For Arduino

FEATURES  Wide voltage range from 3.3V to 5V  Standard assembling structure (two 3mm holes with multiple of 5cm as interval)  Easily recognitive interfaces of sensors (A for analog and D for digital)  Icons to simplely illustrate sensor function  High quality connector  Immersion gold

文件：114.3 Kbytes 页数：3 Pages

DFROBOT

上海智位机器人股份有限公司

Xbee USB adapter (FTDI ready)

FEATURES  Used for the XBee module configuration parameters  Easily connected to a PC via mini USB cable  XBee-setting support software X-CTU  Also used as a USB-TTL adapter  Voltage: +5V(USB Power)

文件：76.21 Kbytes 页数：1 Pages

DFROBOT

上海智位机器人股份有限公司

SD Module (SKU: DFR0071)

Features  Break out board for standard SD card and Micro SD (TF) card  Sits directly on a Arduino  Also be used with other microcontrollers

文件：283.08 Kbytes 页数：6 Pages

DFROBOT

上海智位机器人股份有限公司