Level measurement device with guided radar

The Type 8188 is a level measurement device with cable, rod, both interchangeable probe or with coax probe, designed for continuous level measurement. The unit is suitable for liquids, for industrial use in all areas of process technology. With a measuring range up to 75 m, the 8188 is best sui

文件：1.32825 Mbytes 页数：17 Pages

BURKERT

宝帝流体控制系统

Level measurement device with guided radar - sanitary version

The Type 8189 is a level measurement device with interchangeable rod probe, designed for continuous level measurement. The unit is suitable for liquids, for industrial use in all areas of process technology. But the main application targets are in Food and Beverage (F&B) and pharmaceutical tan

文件：940.95 Kbytes 页数：12 Pages

BURKERT

宝帝流体控制系统

Conductivity meter, ELEMENT design

The Bürkert conductivity meter Type 8222 is designed for measuring the conductivity of fluids. The sensor element comprises a two-electrode cell and a Pt1000 temperature probe. The sensor itself is available with three different cell constants C. These with C= 0.01 or 0.1 cm- 1 are fitted with

文件：1.99861 Mbytes 页数：24 Pages

BURKERT

宝帝流体控制系统

Mass Flow Meter (MFM) for Gases

The mass flow meter (MFM) type 8703 is suited for measuring the mass flow of gases over a big flow range. The thermal MEMS sensor is located directly in the gas stream and therefore reaches very fast response times. Type 8703 can optionally be calibrated for two different gases; the user can sw

文件：1.07856 Mbytes 页数：12 Pages

BURKERT

宝帝流体控制系统

Inline positive displacement (PD) flowmeter or Inline batch controller

The device Type SE35 + S077 is specially designed for continuous flow measurement of highly viscous fluids like glue, honey or oil. slightly aggressive, solid-free liquids. The device is provided as flowmeter or batch controller. The device is made up of a compact Inline sensor-fitting with ova

文件：1.05126 Mbytes 页数：20 Pages

BURKERT

宝帝流体控制系统

Liquid Flow Controller (LFC)

Type 8719 is an instrument for liquid flow control in process technology. The measured value provided by the sensor will be compared in the digital control electronics with the predefined set point according to the signal; if a control difference is present, the control value output to the prop

文件：1.03899 Mbytes 页数：13 Pages

BURKERT

宝帝流体控制系统

Direct-acting 2-way low differential pressure solenoid control valve

The direct-acting proportional valve Type 6024 works as an electromagnetically actuated control valve with relatively high flow rates at low operating pressures. The valve is normally closed. Type description

文件：1.28876 Mbytes 页数：12 Pages

BURKERT

宝帝流体控制系统

Direct-acting 2-way basic proportional valve

Type 2865 is an extremely compact solenoid control valve and is available with an orifice up to 8 mm. It is based on the standard version of Type 2875. It is used as an actuator in closed control loops (pressure, flow, temperature, etc.). Compared with the standard version, the valve is essent

文件：1.36366 Mbytes 页数：14 Pages

BURKERT

宝帝流体控制系统

Direct-acting 2-way standard solenoid control valve

The direct-acting solenoid control valve Type 2871 is used as the regulating unit in control loops. Due to an elastomeric seat seal the valve closes tight (integrated shut-off function) ,up to the DN specific nominal pressure. The plunger of the valve is assembled frictionless, which leads to a

文件：926.26 Kbytes 页数：13 Pages

BURKERT

宝帝流体控制系统

Direct-acting 2-way standard solenoid control valve

The direct-acting solenoid control valve Type 2873 is used as the regulating unit in control loops. Due to an elastomeric seat seal the valve closes tight (integrated shut-off function), up to the DN specific nominal pressure. The plunger of the valve is assembled frictionless, which leads to a

文件：927.96 Kbytes 页数：13 Pages

BURKERT

宝帝流体控制系统