SN74LVTH162245-EP中文资料具有三态输出的增强型产品 3.3V Abt 16 位总线收发器数据手册TI规格书

描述 Description

The SN74LVTH162245 is a 16-bit (dual-octal) noninverting 3-state transceiver designed for low-voltage (3.3-V)VCC operation, but with the capability to provide a TTL interface to a 5-V system environment.
This device can be used as two 8-bit transceivers or one 16-bit transceiver. The device allows data transmissionfrom the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the device so that the buses effectively are isolated.
The A-port outputs, which are designed to source or sink up to 12 mA, include equivalent 22- series resistors to reduce overshoot and undershoot.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
When VCC is between 0 and 1.5 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict.

特性 Features

• Controlled Baseline
• Enhanced Diminishing Manufacturing Sources (DMS) Support
• Qualification Pedigree
• A-Port Outputs Have Equivalent 22- Series Resistors, So No External Resistors Are Required
• Supports Unregulated Battery Operation Down To 2.7 V
• Ioff and Power-Up 3-State Support Hot Insertion
• Distributed VCC and GND Pins Minimize High-Speed Switching Noise
• Latch-Up Performance Exceeds 500 mA Per JESD 17
• 200-V Machine Model (A115-A)
• 1000-V Charged-Device Model (C101)
Component qualification in accordance with JEDEC and industrystandards to ensure reliable operation over an extendedtemperature range. This includes, but is not limited to, HighlyAccelerated Stress Test (HAST) or biased 85/85, temperaturecycle, autoclave or unbiased HAST, electromigration, bondintermetallic life, and mold compound life. Such qualificationtesting should not be viewed as justifying use of this componentbeyond specified performance and environmental limits. Widebus is a trademark of Texas Instruments.