Miniature PMDC Motor

Standard Operating Conditions Rated Voltage : 3V DC Direction of Rotation : CWW Electrical Characteristics (at initial stage after 30 seconds run-in) No Load Current : 0.4A Max. No Load Speed : 16000 ±10%rpm Rated Load : 11.9 g.cm (tested with fan) Rated Current : 1.5A Max. Rated Speed

文件：245.83 Kbytes 页数：1 Pages

MULTICOMP

易络盟

丝印：MM10G3T120B；Package：TO-247；1200V 10A IGBT

文件：668.45 Kbytes 页数：5 Pages

MACMIC

宏微科技

Video Amplifier

Outline This IC is a video amplifier that can perform superimpose. It has a built-in 75Ω driver. Features 1. Built-in superimpose function 2. Built-in Y-C mix circuit 3. Vertical/horizontal sync signal output pin 4. Built-in clamp circuit (for Y signal only) 5. 75Ωdriver bui

文件：104.41 Kbytes 页数：6 Pages

MITSUMI

三美

Video Amplifier

Outline This IC is a video amplifier that can perform superimpose. It has a built-in 75Ω driver. Features 1. Built-in superimpose function 2. Built-in Y-C mix circuit 3. Vertical/horizontal sync signal output pin 4. Built-in clamp circuit (for Y signal only) 5. 75Ωdriver bui

文件：104.41 Kbytes 页数：6 Pages

MITSUMI

三美

HBS-Compatible Driver and Receiver

Outline This IC conforms to the HBS (Home Bus) specification (Electronic Industries Association of Japan), and has functions for the reception and transmission of data. AMI is adopted for the waveforms of signals handled by the transmission and reception units, designed for connection to twiste

文件：133.6 Kbytes 页数：4 Pages

MITSUMI

三美

S Video Amplifier Monolithic IC MM1024

Outline This is a video amp IC that supports S and also has border and superimpose functions. Amp gain is as follows : 6dB for Y signal amplification, 10dB for C signal amplification and 6dB for composite signal amplification. A 75Ω driver is built in. Features 1. Supports S-VHS 2. Built-in su

文件：146.21 Kbytes 页数：5 Pages

MITSUMI

三美

S Video Amplifier Monolithic IC MM1024

Outline This is a video amp IC that supports S and also has border and superimpose functions. Amp gain is as follows : 6dB for Y signal amplification, 10dB for C signal amplification and 6dB for composite signal amplification. A 75Ω driver is built in. Features 1. Supports S-VHS 2. Built-in su

文件：146.21 Kbytes 页数：5 Pages

MITSUMI

三美

System Reset (with battery back-up) Monolithic IC

Outline These ICs were developed for D-RAM and dummy S-RAM battery back-up. D-RAM and dummy S-RAM power supplies differ from that of S-RAMs because 5V or 3.3V of power supply is required even during battery back-up. Therefore, these ICs provide voltage from a stable power supply during both norma

文件：63.95 Kbytes 页数：6 Pages

MITSUMI

三美

System Reset (with battery back-up) Monolithic IC

Outline These ICs were developed for STATIC-RAM (S-RAM) battery back-up, and have built-in switching circuit for main power supply and battery, back-up timing circuit and battery checker. Features 1. Battery back-up 1. Low IC current consumption (loss current) 0.3µA typ. 2. Dr

文件：121.6 Kbytes 页数：11 Pages

MITSUMI

三美

System Reset (with battery back-up) Monolithic IC

Outline These ICs were developed for STATIC-RAM (S-RAM) battery back-up, and have built-in switching circuit for main power supply and battery, back-up timing circuit and battery checker. Features 1. Battery back-up 1. Low IC current consumption (loss current) 0.3µA typ. 2. Dr

文件：121.6 Kbytes 页数：11 Pages

MITSUMI

三美