MC100EP195数据手册集成电路（IC）的延迟线规格书PDF

描述 Description

NECL/PECL input transition.The delay section consists of a programmable matrix of gates and multiplexers as shown in the data sheet logic diagram. The delay increment of the EP195 has a digitally selectable resolution of about 10 ps and a range of up to 10.2 ns. The required delay is selected by the 10 data select inputs D(0:9) which are latched on chip by a high signal on the latch enable (LEN) control. The MC10/100EP195 is a programmable delay chip (PDC) designed primarily for clock deskewing and timing adjustment. It provides variable delay of a differential The approximate delay values for varying tap numbers correlating to D0 (LSB) through D9 (MSB) are shown in the data sheet.Because the EP195 is designed using a chain of multiplexers it has a fixed minimum delay of 2.2 ns. An additional pin D10 is provided for cascading multiple PDCs for increased programmable range. The cascade logic allows full control of multiple PDCs. Select input pins D0-D10 may be threshold controlled by combinations of interconnects between VEF (pin 7) and VCF (pin 8) for CMOS, ECL, or TTL level signals. For CMOS input levels, leave VCF and VEF open. For ECL operation, short VCF and VEF (pins 7 and 8). For TTL level operation, connect a 1.5 V supply reference to VCF and leave open VEF pin. The 1.5 V reference voltage to VCF pin can be accomplished by placing a 1.5k Ohm or 500 Ohm resistor between VCF and VEE for 3.3 V or 5.0 V power supplies, respectively. The VBB pin, an internally generated voltage supply, is available to this device only. For single-ended input conditions, the unused differential input is connected to VBB as a switching reference voltage. VBB may also rebias AC coupled inputs. When used, decouple VBB and VCC via a 0.01 uF capacitor and limit current sourcing or

特性 Features

• Maximum Frequency > 1.2 Ghz Typical
• Programmable Range: 2.2 ns to 12.2 ns
• 10 ps Increments
• PECL Mode Operating Range: VCC = 3.0 V with VEE = 0 V
• NECL Mode Operating Range: VCC = 0 V with VEE = -3.0 V
• Open Input Default State
• Safety Clamp on Inputs
• A Logic High on the ENbar Pin Will Force Q to Logic Low
• D[0:10] Can Accept Either ECL, CMOS, or TTL Inputs.
• VBB Output Reference Voltage
• Pb-Free Packages are Available

应用 Application

• Automated Test Equipement (ATE)
• General Purpose Data and Clock Interface

简介

MC100EP195属于集成电路（IC）的延迟线。由制造生产的MC100EP195延迟线时钟延迟线产品族中的产品属于数字器件，用于在数字信号中引入时间延迟，以便将提交给器件输入的信号跃迁，经过某一已知时间之后在输出端复现。它们常用于高速数字系统，以校正或补偿不同信号路径之间的信号传播时间的偏差。这些器件可用于产生固定、可选或可变持续时间的延迟。