3-PHASE STEPPER OR BLDC MOTOR CONTROLLER WITH LIN 2.x or PWM

文件：689.69 Kbytes 页数：15 Pages

ELMOS

3-PHASE STEPPER OR BLDC MOTOR CONTROLLER WITH LIN 2.x or PWM

文件：689.69 Kbytes 页数：15 Pages

ELMOS

LIN 2.x OR PWM-INTERFACE STEPPER WITH STALL DETECTION

文件：210.07 Kbytes 页数：2 Pages

ELMOS

LIN 2.x OR PWM-INTERFACE STEPPER WITH STALL DETECTION

文件：210.07 Kbytes 页数：2 Pages

ELMOS

B6 Bridge FET Driver (LIN/PWM Interface)

This IC controls up to 3 NMOS half bridges for driving BLDC motors, DC motors, or other loads. It’s also possible to drive loads directly at battery supply. The IC supports an external μC with a power supply (3.3V or 5V),... read more • Gate drive circuit for B6-NMOS bridge\n • Voltage range 7V to 28V (5V to 42V peak)\n • LIN 2.x (1.3, SAE-J2602 comp.) or PWM bidirectional\n • Software update via LIN high speed mode\n • Precise, dynamical dead-time generation\n • Voltage regulator for μC 3.3V or 5V, up to 70mA direct load\n • Sep;

Elmos

艾尔默斯

LIN2.x Relay Node SBC for 4/3 Relays

The Elmos System-Basis-Chip (SBC) family E523.02/12 controls controlsfour relays either low-side or high-side driven or three bistable relays(activation in sequential order). The relay holding current can beprogrammed... read more • Voltage range 7V to 28V (5V to 42V peak)\n• Controls 4relays, low- or high-side driven or 3 bistable relays \n• Relay pull-in and holding current can be controlled via PWM input \n• Power supply 3.3V or 5VC for external controller \n• LIN 2.x interface (1.3), SAE-J2602or PWM bidirectional\n• Sever;

Elmos

艾尔默斯

DC MOTOR LS FET DRIVER WITH μC SUPPLY AND LIN 2.X

Elmos

艾尔默斯