1 to 4 W audio power amplifier

The TDA1015 is a monolithic integrated audio amplifier circuit in a 9-lead single in-line (SIL) plastic package. The device is especially designed for portable radio and recorder applications and delivers up to 4 W in a 4 Ωload impedance. The very low applicable supply voltage of 3,6 V permits 6 V

文件：253.65 Kbytes 页数：13 Pages

PHI

PHI

0,5 W audio power amplifier

GENERAL DESCRIPTION The TDA1015T is a low-cost audio amplifier which can deliver up to 0,5 W output power into a 16Ωload impedance at a supply voltage of 9 V. The amplifier is specially designed for portable applications such as radios and recorders. The IC has a very low supply voltage require

文件：75.01 Kbytes 页数：10 Pages

PHI

PHI

Recording/playback and 2 W audio power amplifier

GENERAL DESCRIPTION The TDA1016 is a monolithic integrated audio power amplifier, preamplifier and A.L.C. circuit designed for applications in radio-recorders and recorders. The wide supply voltage range makes this circuit very suitable for d.c. and a.c. apparatus. The circuit incorporates the fo

文件：58.14 Kbytes 页数：9 Pages

PHI

PHI

12 W car radio power amplifier

The TDA1020 is a monolithic integrated 12 W audio amplifier in a 9-lead single in-line (SIL) plastic package. The device is primarily developed as a car radio amplifier. At a supply voltage of VP = 14,4 V, an output power of 7 W can be delivered into a 4 Ω load and 12 W into 2 Ω. To avoid inter

文件：69.55 Kbytes 页数：9 Pages

PHI

PHI

BUCKET BRIGADE DELAY LINE FOR ANALOGUE SIGNALS

BUCKET BRIGADE DELAY LINE FOR ANALOGUE SIGNALS The TDA1022 is a MOS monolithic integrated circuit, generally intended to delay analogus signals (e.g. delay time = 512/2 fø) It can be used with clock frequencies in the range 5 kHz to 500 kHz. The device contains 512 stages, so the input signal c

文件：351.25 Kbytes 页数：10 Pages

ETCList of Unclassifed Manufacturers

未分类制造商

Proportional-control triac triggering circuit

GENERAL DESCRIPTION The TDA1023 is a bipolar integrated circuit for controlling triacs in a proportional time or burst firing mode. Permitting precise temperature control of heating equipment it is especially suited to the control of panel heaters. It generates positive-going trigge

文件：266.53 Kbytes 页数：19 Pages

PHI

PHI

Proportional-control triac triggering circuit

GENERAL DESCRIPTION The TDA1023 is a bipolar integrated circuit for controlling triacs in a proportional time or burst firing mode. Permitting precise temperature control of heating equipment it is especially suited to the control of panel heaters. It generates positive-going trigge

文件：266.53 Kbytes 页数：19 Pages

PHI

PHI

A MAIN-ZERO TRIAC-TRIGGERING CIRCUIT

文件：617.22 Kbytes 页数：15 Pages

PHI

PHI

Signal-sources switch

Signal-sources switch The TDA1029 is a dual operational amplifier (connected as an impedance converter) each amplifier having 4 mutually switchable inputs which are protected by clamping diodes. The input currents are independent of switch position and the outputs are short-circuit protected.

文件：235.32 Kbytes 页数：16 Pages

PHI

PHI

TDA1034 Series - Operational Amplifier

GENERAL DESCRIPTION The TDA1034 is a high-performance general purpose operational amplifier. Compared to most of the standard operational amplifiers (e.g. uA741, TBA221, LM301A and LM307), it shows better noise performance, improved out- put drive capability and considerably higher small-si

文件：209.39 Kbytes 页数：7 Pages

ETCList of Unclassifed Manufacturers

未分类制造商