SN74AVCH4T245-EP中文资料具有可配置电压转换和三态输出的增强型产品 4 位双电源总线收发器数据手册TI规格书

描述 Description

This 4-bit noninverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.2 V to 3.6 V. The SN74AVCH4T245 is optimized to operate with VCCA/VCCB set at 1.4 V to 3.6 V. It is operational with VCCA/VCCB as low as 1.2 V. This allows for universal low-voltage bidirectional translation between any of the 1.2-V, 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes. The SN74AVCH4T245 is designed for asynchronous communication between two data buses. The logic levels of the direction-control (DIR) input and the output-enable (OE) input activate either the B-port outputs or the A-port outputs or place both output ports into the high-impedance mode. The device transmits data from the A bus to the B bus when the B-port outputs are activated, and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports is always active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ. The SN74AVCH4T245 is designed so that the control pins (1DIR, 2DIR, 1OE, and 2OE) are supplied by VCCA. This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. The VCC isolation feature ensures that if either VCC input is at GND, then both ports are in the high-impedance state. The bus-hold circuitry on the powered-up side always stays active. Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

特性 Features

• Control Inputs VIH/VIL Levels Are Referenced to VCCA Voltage
• I/Os Are 4.6-V Tolerant
• Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
• 380 Mbps (1.8-V to 3.3-V Translation)
• Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
• 8000-V Human-Body Model (A114-A)
• 1000-V Charged-Device Model (C101)
• SUPPORTS DEFENSE, AEROSPACE, AND MEDICAL APPLICATIONS
• One Assembly/Test Site
• Available in Military (–55°C/125°C) Temperature Range
• Extended Product-Change Notification
• Product Traceability


Additional temperature ranges are available – contact factory