SC28L92中文资料飞利浦数据手册PDF规格书

DESCRIPTION

The SC28L92 is a pin and function replacement for the SCC2692 and SC26C92 operating at 3.3 or 5 volts supply with added features and deeper FIFOs. Its configuration on power up is that of the SC26C92. Its differences from the 2692 are: 16 character receiver, 16 character transmit FIFOs, watch dog timer for each receiver, mode register 0 is added, extended baud rate and overall faster speeds, programmable receiver and transmitter interrupts. (Neither the SC26C92 nor the SCC2692 is being discontinued.)

FEATURES

• Member of IMPACT family: 3.3 to 5.0 volt , –40°C to +85°C and 68K for 80xxx bus interface for all devices.

• Dual full-duplex independent asynchronous receiver/transmitters

• 16 character FIFOs for each receiver and transmitter

• Pin programming selects 68K or 80xxx bus interface

• Programmable data format

– 5 to 8 data bits plus parity

– Odd, even, no parity or force parity

– - 1, 1.5 or 2 stop bits programmable in 1/16-bit increments

• 16-bit programmable Counter/Timer

• Programmable baud rate for each receiver and transmitter selectable from:

– 28 fixed rates: 50 to 230.4k baud

– Other baud rates to MHz at 16X

– Programmable user-defined rates derived from a programmable counter/timer

– External 1X or 16X clock

• Parity, framing, and overrun error detection

• False start bit detection

• Line break detection and generation

• Programmable channel mode

– Normal (full-duplex)

– Automatic echo

– Local loop back

– Remote loop back

– Multi-drop mode (also called ‘wake-up’ or ‘9-bit’)

• Multi-function 7-bit input port (includes IACKN)

– Can serve as clock or control inputs

– Change of state detection on four inputs

– Inputs have typically >100k pull-up resistors

– Change of state detectors for modem control

• Multi-function 8-bit output port

– Individual bit set/reset capability

– Outputs can be programmed to be status/interrupt signals

– FIFO status for DMA interface

• Versatile interrupt system

– Single interrupt output with eight maskable interrupting conditions

– Output port can be configured to provide a total of up to six separate interrupt outputs that may be wire ORed.

– Each FIFO can be programmed for four different interrupt levels

– Watch dog timer for each receiver

• Maximum data transfer rates: 1X – 1Mb/sec, 16X – 1Mb/sec

• Automatic wake-up mode for multi-drop applications

• Start-end break interrupt/status

• Detects break which originates in the middle of a character

• On-chip crystal oscillator

• Power down mode

• Receiver time-out mode

• Single +3.3V or +5V power supply

• Powers up to emulate SC26C92