SC28L198A1中文资料飞利浦数据手册PDF规格书

FUNCTIONAL DESCRIPTION

The SC28L198 is composed of several functional blocks:

• Synchronous host interface block

• A timing block consisting of a common baud rate generator making 22 industry standard baud rates and 2 16–bit counters used for non–standard baud rate generation

• 4 identical independent full duplex UART channel blocks

• Interrupt arbitration system evaluating 24 contenders

• I/O port control section and change of state detectors.

FEATURES

• Single 3.3V and 5V power supply

• Eight Philips industry standard full duplex UART channels

• Sixteen byte receiver FIFOs for each UART

• Sixteen byte transmit FIFOs for each UART

• In band flow control using programmable Xon/Xoff characters

• Flow control using CTSN RTSN hardware handshaking

• Automatic address detection in multi-drop mode

• Three byte general purpose character recognition

• Fast data bus, 30 ns data bus release time, 125 ns bus cycle time

• Programmable interrupt priorities

• Automatic identification of highest priority interrupt pending

• Global interrupt and control registers ease setup and interrupt handling

• Vectored interrupts with programmable interrupt vector formats

– Interrupt vector modified with channel number

– Interrupt vector modified with channel number and channel type

– Interrupt vector not modified

• IACKN and DACKN signal pins

• Watch dog timer for each receiver (64 receive clock counts)

• Programmable Data Formats:

– 5 to 8 data bits plus parity

– Odd, even force or no parity

– 1, 1.5 or 2 stop bits

• Flexible baud rate selection for receivers and transmitters:

– 22 fixed rates; 50 – 230.4K baud or 100 to 460.8K baud

– Additional non–standard rates to 500K baud with internal generators

– Two reload–counters provide additional programmable baud rate generation

– External 1x or 16x clock inputs

– Simplified baud rate selection

• 1 MHz 1x and 16x data rates full duplex all channels.

• Parity, framing and overrun error detection

• False start bit detection

• Line break detection and generation

• Programmable channel mode

– Normal(full duplex)

– Diagnostic modes

automatic echo

local loop back

emote loop back

• Four I/O ports per UART for modem controls, clocks, RTSN, I/O etc.

– All I/O ports equipped with ”Change of State Detectors”

• Two global inputs and two global outputs for general purpose I/O

• Power down mode

• On chip crystal oscillator, 2–8 MHz

• TTL input levels. Outputs switch between full VCC and VSS

• High speed CMOS technology

• 84 pin PLCC

• 100 pin LQFP

Uses

Statistical Multiplexers

Data Concentrators

Packet–switching networks

Process Control

Building or Plant Control

Laboratory data gathering

ISDN front ends

Computer Networks

Point–of–Sale terminals

Automotive, cab and engine controls

Entertainment systems

MIDDI keyboard control music systems

Theater lighting control

Terminal Servers

Computer–Printer/Plotter links