PCA9560PW中文资料Dual 5-bit multiplexed 1-bit latched I2C EEPROM DIP switch数据手册恩XP规格书

描述 Description

The PCA9560 is a 20-pin CMOS device consisting of two 6-bit non-volatile EEPROM registers, 5 hardware pin inputs and a 5-bit multiplexed output with one latched EEPROM bit. It is used for DIP switch-free or jumper-less system configuration and supports Mobile and Desktop VID Configuration, where 3 preset values (2 sets of internal non-volatile registers and 1 set of external hardware pins) set processor voltage for operation in either performance, deep sleep or deeper sleep modes. The PCA9560 is also useful in server and telecom/networking applications when used to replace DIP switches or jumpers, since the settings can be easily changed via I²C/SMBus without having to power down the equipment to open the cabinet. The non-volatile memory retains the most current setting selected before the power is turned off.
The PCA9560 typically resides between the CPU and Voltage Regulator Module (VRM) when used for CPU VID (Voltage IDentification code) configuration. It is used to bypass the CPU-defined VID values and provide a different set of VID values to the VRM, if an increase in the CPU voltage is desired. An increase in CPU voltage combined with an increase in CPU frequency leads to a performance boost of up to 7.5pct. Lower CPU voltage reduces power consumption. The main advantage of the PCA9560 over the older PCA9559 device in this application is that it contains two internal non-volatile EEPROM registers instead of just one, allowing three independent settings (performance operation, deep sleep mode and deeper sleep mode) instead of only two (performance operation and deep sleep mode). The PCA9560 is footprint compatible and a drop-in replacement for the PCA9559, without any software modifications required.
The PCA9560 has 2 address pins allow up to 4 devices to be placed on the same I²C bus or SMBus.

特性 Features

5-bit 3-to-1 multiplexer, 1-bit latch DIP switch
5-bit external hardware pins
Two 6-bit internal non-volatile registers, fully pin-to-pin compatible with PCA9559
Selection between the two non-volatile registers
Selection between non-volatile registers and external hardware pins
I²C/SMBus interface logic
Internal pull-up resistors on input pin and control signals
Active high write protect on input controls the ability to write to the non-volatile registers
2 address pins, allowing up to 4 devices on the I²C-bus
5 open drain multiplexed outputs
Open drain non-multiplexed output
Internal 6-bit non-volatile registers programmable and readable via I²C-bus
External hardware 5-bit value readable via I²C-bus
Multiplexer selection can be overridden by I²C-bus
Operating power supply voltage 3.0 V to 3.6 V
5 V and 2.5 V tolerant inputs/outputs
0 to 400 kHz clock frequency
ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per JESD22-A115, and 1000 V CDM per JESD22-C101
Latch-up testing is done to JESDEC Standard JESD78 which exceeds 100 mA.
Package offering: SO20, TSSOP20