ADUM5402CRWZ现货库存销售

2014-8-5 14:50:00
  • FEATURES isoPower integrated, isolated dc-to-dc converter Regulated 3.3 V or 5.0 V output Up to 500 mW output power Quad dc-to-25 Mbps (NRZ) signal isolation channels 16-lead SOIC package with 7.6 mm creepage High temperature operation: 105°C maximum High common-mode transient immunity: >25 kV/μ

FEATURES isoPower integrated, isolated dc-to-dc converter Regulated 3.3 V or 5.0 V output Up to 500 mW output power Quad dc-to-25 Mbps (NRZ) signal isolation channels 16-lead SOIC package with 7.6 mm creepage High temperature operation: 105°C maximum High common-mode transient immunity: >25 kV/μs Safety and regulatory approvals UL recognition 2500 V rms for 1 minute per UL 1577 CSA Component Acceptance Notice #5A VDE certificate of conformity (pending) IEC 60747-5-2 (VDE 0884, Part 2) VIORM = 560 V peak APPLICATIONS RS-232/RS-422/RS-485 transceivers Industrial field bus isolation Power supply start-up bias and gate drives Isolated sensor interfaces Industrial PLCs GENERAL DESCRIPTION The ADuM5401/ADuM5402/ADuM5403/ADuM5404 1 are quad-channel digital isolators with isoPower?, an integrated, isolated dc-to-dc converter. Based on the Analog Devices, Inc., iCoupler? technology, the dc-to-dc converter provides up to 500 mW of regulated, isolated power at either 5.0 V or 3.3 V from a 5.0 V input supply, or at 3.3 V from a 3.3 V supply at the power levels shown in Table 1. These devices eliminate the need for a separate, isolated dc-to-dc converter in low power, isolated designs. The iCoupler chip scale transformer technology is used to isolate the logic signals and for the power and feedback paths in the dc-to-dc converter. The result is a small form factor, total isolation solution. The ADuM5401/ADuM5402/ADuM5403/ADuM5404 isolators provide four independent isolation channels in a variety of channel configurations and data rates (see the Ordering Guide for more information). isoPower uses high frequency switching elements to transfer power through its transformer. Special care must be taken during printed circuit board (PCB) layout to meet emissions standards. See the AN-0971 Application Note for board layout recommendations.

专业代理,全新到货,大量现货欢迎询问!!!

质优价廉,品质保证!

批号:13+

专业代理全线产品,优势的进货渠道,专业的销售团队,一手货源,全国最低价供应!

为您提供专业、快捷、可靠的产品

深圳德田科技有限公司

Shenzhen Spring Technology Co.,Ltd

地址:深圳市福田区振华路122号海外装饰大厦A座211室

Shenzhen futian district zhenhua road 122 overseas decoration building, room 211, block A, 518031

李先生

电话(Tel):(+86-755) 8350 5153

传真(Fax):(+86-755) 8350 2530

邮箱: info@dt-ic.com

网址:www.dt-ic.com