DM9102D中文资料Single Chip Fast Ethernet NIC Controller数据手册Davicom规格书

描述 Description

The DM9102D is a fully integrated and cost effective single chip Fast Ethernet NIC controller with PCI interface. It is designed with low power and high performance process. It is a 2.5V/3.3V device with 5V tolerance.

特性 Features

·Zero copy supporting
·Comply with ACPI and PCI Bus Power Management
·Support the MII (Media Independent Interface) for an external PHY
·Support Wake-On-LAN function and remote wake-up
·Support 4 Wake-On-LAN (WOL) signals
·High performance 100Mbps clock generator and data recovery circuit
·Digital clock recovery circuit, using advanced digital algorithm to reduce jitter
·Adaptive equalization circuit and baseline wandering restoration circuit 100Mbps receiver
·Provides loopback mode for easy system diagnostics
·Support HP Auto-MDIX
·Low power consumption modes:
·- Power reduced mode (cable detection)
·- Power down mode
·- Selectable TX drivers for 1:1 or 1.25:1 transformers for additional power reduction
·Integrated Fast Ethernet MAC, Physical Layer and transceiver in one chip
·128 pin LQFP with CMOS process
·+2.5/3.3V Power supply with +5V tolerant I/O
·Comply with PCI specification 2.2
·PCI bus master architecture
·PCI bus burst mode data transfer
·Two large independent transmission and receipt FIFO
·Up to 256K bytes Boot EPROM or Flash interface
·EEPROM 93C46 interface automatically supports node ID load and configuration information
·Comply with IEEE 802.3u 100Base-TX and 802.3 10Base-T
·Comply with IEEE 802.3u auto-negotiation protocol for automatic link type selection
·Support IEEE 802.3x Full Duplex Flow Control
·VLAN frame length support
·IP/TCP/UDP checksum generation and checking