V62/03603-01XE中文资料德州仪器数据手册PDF规格书

Controlled Baseline

– One Assembly/Test Site, One Fabrication

Site

Extended Temperature Performance of

–40°C to 125°C

Enhanced Diminishing Manufacturing

Sources (DMS) Support

Enhanced Product Change Notification

Qualification Pedigree†

Member of the Texas Instruments

Widebus Family

Inputs Are TTL-Voltage Compatible

3-State Bus Driving True Outputs

Flow-Through Architecture Optimizes

PCB Layout

Distributed VCC and GND Pins Minimize

High-Speed Switching Noise

description

The SN74ACT16374Q-EP is a 16-bit

edge-triggered D-type flip-flop with 3-state

outputs, designed specifically for driving highly

capacitive or relatively low-impedance loads. It is

particularly suitable for implementing buffer

registers, I/O ports, bidirectional bus drivers, and

working registers.

This device can be used as two 8-bit flip-flops or one 16-bit flip-flop. On the positive transition of the clock (CLK)

input, the Q outputs of the flip-flop take on the logic levels set up at the data (D) inputs.

An output-enable (OE) input can be used to place the outputs in either a normal logic state (high or low logic

levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines

significantly. The high-impedance state provides the capability to drive bus lines in a bus-organized system,

without need for interface or pullup components. OE does not affect the internal operations of the flip-flop. Old

data can be retained or new data can be entered while the outputs are in the high-impedance state.