TDA8552T数据手册恩XP中文资料规格书

描述 Description

Overview
The TDA8552T is a two channel audio power amplifier that provides an output power of 2 x 1.4 W into an 8 Ω load using a 5 V power supply. The circuit contains two BTL power amplifiers, two digital volume controls and standby/mute logic. Volume and balance of the amplifiers are controlled using two digital input pins which can be driven by simple push-buttons or by a microcontroller. Using the selection pin (GAINSEL) the maximum gain can be set at 20 or 30 dB. The headphone sense input (HPS) can be used to detect if a headphone is plugged into the jack connector. If a headphone is plugged into the jack connector the amplifier switches from the BTL to the SE mode and the BTL loudspeakers are switched off. This also results in a reduction of quiescent current consumption.

The TDA8552T is contained in a 20-pin small outline package. For the TDA8552TS, which is contained in a 20-pin very small outline package, the maximum output power is limited by the maximum allowed ambient temperature. More information can be found in Section \"Thermal design considerations\". The SO20 package has the four corner leads connected to the die pad so that the thermal behaviour can be improved by the PCB layout.

特性 Features

One pin digital volume control (for each channel)

Volume setting with up/down pulses

Auto repeat function on volume setting

Headphone sensing

Maximum gain set by selection pin

Low sensitivity for EMC radiation

Internal feedback resistors

Flexibility in use

Few external components

Low saturation voltage of output stage

Standby mode controlled by CMOS compatible levels

Low standby current

No switch-on/switch-off plops

High supply voltage ripple rejection

Protected against electrostatic discharge

Outputs short-circuit safe to ground, VDD and across the load

Thermally protected.

应用 Application

Portable consumer products

Notebook computers

Communication equipment.