基于SaTCR的LNB和切换器的DiSEqC从设备微控制器

The STM8SPLNB1 is an 8-bit microcontroller dedicated to DiSEqC slave operation in SaTCR based LNBs (Low Noise Block) and switchers.\n\n It is a complete hardware and firmware solution for system designers who require an implementation overview of the LNB device control according to DiSEqC standard ( • Clock, reset and supply management \n •Reduced power consumption, \n •Safe power on/off managementby low voltage detector (LVD), \n •2.95 to 5.5 V operating voltage, \n •Internal 16MHz oscillator. \n• Communication interface \n •Two DiSEqCTM communication interfaces, \n •Four I2C communication int;

ST

意法半导体

Internal 16MHz oscillator

文件：743.54 Kbytes 页数：44 Pages

STMICROELECTRONICS

意法半导体

Package：20-SOIC（0.295"，7.50mm 宽）；包装：托盘 类别：集成电路（IC） 应用特定微控制器 描述：IC MCU 8BIT DISEQC 20SOIC

STMICROELECTRONICS

意法半导体

Package：20-TSSOP（0.173"，4.40mm 宽）；包装：托盘 类别：集成电路（IC） 应用特定微控制器 描述：IC MCU SLAVE DISEQC 20TSSOP

STMICROELECTRONICS

意法半导体