SN74AUCH245RGYR集成电路（IC）的缓冲器驱动器接收器收发器规格书PDF中文资料

SN74AUCH245RGYR属于集成电路（IC）的缓冲器驱动器接收器收发器。由德州仪器制造生产的SN74AUCH245RGYR缓冲器，驱动器，接收器，收发器逻辑缓冲器、驱动器、接收器和收发器允许隔离对某个电路的逻辑信号的访问，以用于另一电路。缓冲器将其输入信号（不变或反相）传递到其输出，并可能用于清除弱信号或驱动负载。在布尔逻辑仿真器中，缓冲器主要用于增加传播延迟。逻辑接收器和收发器允许在数据总线之间进行隔离通信。

Optimized for 1.8-V Operation and Is 3.6-V

I/O Tolerant to Support Mixed-Mode Signal

Operation

Ioff Supports Partial-Power-Down Mode

Operation

Sub 1-V Operable

Max tpd of 2 ns at 1.8 V

Low Power Consumption, 20-μA Max ICC

±8-mA Output Drive at 1.8 V

Bus Hold on Data Inputs Eliminates the

Need for External Pullup/Pulldown

Resistors

Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

ESD Protection Exceeds JESD 22

– 2000-V Human-Body Model (A114-A)

– 200-V Machine Model (A115-A)

– 1000-V Charged-Device Model (C101)

description/ordering information

This octal bus transceiver is operational at 0.8-V to 2.7-V VCC, but is designed specifically for 1.65-V to 1.95-V

VCC operation.

The SN74AUCH245 is designed for asynchronous communication between data buses. The device transmits

data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the

direction-control (DIR) input. The output-enable (OE) input can be used to disable the device so the buses are

effectively isolated.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors

with the bus-hold circuitry is not recommended.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs,

preventing damaging current backflow through the device when it is powered down.