SN74ABT162601数据手册集成电路（IC）的通用总线功能规格书PDF

描述 Description

These 18-bit universal bus transceivers combine D-type latches and D-type flip-flops to allow data flow in transparent, latched, and clocked modes.Data flow in each direction is controlled by output-enable (OEAB\\ and OEBA\\), latch-enable (LEAB and LEBA), and clock (CLKAB and CLKBA) inputs. The clock can be controlled by the clock-enable (CLKENAB\\ and CLKENBA\\) inputs. For A-to-B data flow, the device operates in the transparent mode when LEAB is high. When LEAB is low, the A data is latched if CLKAB is held at a high or low logic level. If LEAB is low, the A data is stored in the latch/flip-flop on the low-to-high transition of CLKAB. Output-enable OEAB\\ is active-low. When OEAB\\ is low, the outputs are active. When OEAB\\ is high, the outputs are in the high-impedance state. Data flow for B to A is similar to that of A to B but uses OEBA\\, LEBA, CLKBA, and CLKENBA\\. The B-port outputs, which are designed to source or sink up to 12 mA, include equivalent 25- series resistors to reduce overshoot and undershoot. When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.The SN54ABT162601 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT162601 is characterized for operation from -40°C to 85°C.

特性 Features

• Members of the Texas InstrumentsWidebusTM Family
• B-Port Outputs Have Equivalent 25- Series Resistors, So No External Resistors Are Required
• State-of-the-ArtEPIC-II BTM BiCMOS Design Significantly Reduces Power Dissipation
• UBTTM (Universal Bus Transceiver) Combines D-Type Latches and D-Type Flip-Flops for Operation in Transparent, Latched, Clocked, or Clock-Enabled Mode
• Latch-Up Performance Exceeds 500 mA Per JESD 17
• Typical VOLP (Output Ground Bounce) CC = 5 V, TA = 25°C
• High-Impedance State During Power Up and Power Down
• Flow-Through Architecture Optimizes PCB Layout
• Package Options Include Plastic 300-mil Shrink Small-Outline (DL) and Thin Shrink Small-Outline (DGG) Packages and 380-mil Fine-Pitch Ceramic Flat (WD) Package Using 25-mil Center-to-Center Spacings Widebus, EPIC-IIB, and UBT are trademarks of Texas Instruments Incorporated.