R2A20104SPW5中文资料瑞萨数据手册PDF规格书

Description

R2A20114 series is a boost converter control IC with PFC (Power Factor Correction). Employing continuous conduction mode interleaving PFC, it performs higher efficiency and lower switching noise even for high power use. The control of continuous conduction mode is carried out by detecting the current in power MOSFET. The R2A20114 series supports two types of current detection methods; current detection by current transformers (R2A20104SP/FP), and that by shunt resisters (R2A20114SP/FP). So that, it can be applicable for a variety of applications. Interleaving control of the boost converters, namely, producing 180 degrees phase shift between the output signals (GD1,2) driving the boost converters, enables the system to perform high conversion efficiency and low switching noises and, at the same time, to reduces ripple currents in input and output current and then this allows use of smaller components such as boost inductors, input filters and output capacitors. R2A20114 series integrates a various kinds of protection circuits, such as the detection circuit of breaking of wire in feedback loop, two modes of over voltage protection circuits, over current protection circuit and error output circuit (*1), which improve the reliability of the power supply system and reduce the number of component parts on the system.

Features

• Maximum Ratings

- Supply voltage Vcc: 24 V

- Operating junction temperature Tjopr: from –40 to +150 degrees centigrade

• Electrical characteristics

- VFB feedback voltage VREF: 2.5 V  1.5

- UVLO (Undervoltage Lockout) operation start voltage VH: 10.4 V  0.7 V

- UVLO operation shutdown voltage VL: 8.9 V  0.5 V

- UVLO hysteresis voltage Hysuvl : 1.5 V  0.5 V

• Functions

- Boost converter control with continuous conduction mode

- Interleaving control

- Frequency modulation (*2)

- Brownout

- Phase drop (*1)

- External clock synchronization input

- External clock synchronization output (*1)

- Two modes of over voltage protections

Mode 1: Dynamic OVP preventing over voltage after sudden variation of load.

Mode 2: Static OVP preventing over voltage in the period of normal operation.

- Feedback loop wire breaking/open detector

- Dual over voltage protection circuits (*1): FB and OVP2 terminals

- Current balance control

- Phase 1 and Phase 2 independent over current protection

- Package line-up

Pb-free LQFP-40 (R2A20104FP, R2A20114FP)

Pb-free SOP-20 (R2A20104SP, R2A20114SP)