PMB2314RF/IF射频/中频RFID的RFIC模块规格书PDF中文资料

PMB2314属于RF/IF射频/中频RFID的RFIC模块。由英飞凌科技股份公司制造生产的PMB2314RF 其它 IC 和模块RF 其它 IC 和模块产品系列包含各种独特、专门或特定用途的产品，可与 RF、IF 和微波无线电应用结合使用。示例包括 AM/FM 调谐器和接收器、偏置网络、基带处理器、计数器、数字可调电容器、下变频器、倍频器、移相器、前置分频器、端接器、上变频器、VCO 等。

Functional Description/ Application

The IC is designed for use in mobile radio communication devices up to 2100 MHz and upconversion systems up 2500 MHz.

Due to low power consumption and low phase noise generation, the PMB2314T is suitable for use in battery powered handheld systems, e.g. GSM, cordless telephones and cordless consumer products, as well as in basestations.

Low supply voltage down to 2.7V. It can be switched to a low-power standby mode.

Internal current source at the emitter follower output. No external resistor needed in typical applications.

The divide ratio is 1:64/65 or 1:128/129 depending on the external circuit configuration.

Circuit Description

The differential inputs of the IC may be connected either balanced or single ended. In the latter case the unused input must be RF-grounded with a capacitor (about 10 pF) with a low serial inductance.

Depending on the logic level at SW input the basic divide ratio of the ECL-stages is fixed to 1:64/65 or 1:128/129.

The MOD input determines whether modulus 1:n or 1:n+1 (n=64 or 128 according to SW-level) is active.

The IC can be switched to a low-power standby mode (input STB).

The MOD input is TTL/CMOS compatible.

The emitter follower output is CMOS compatible according to the application circuit on page 12. The minimum logic swing is 0.8 Vpp.