PGM

Small size ??7mm Height

PGM2004-PP

(PGM) Light Dependent resistors / CdS Photoresistor; • Epoxy or hermetical package\n• Good Characteristic of Spectrum\n• Quick Response, Reliable Performance\n;

The cadmium sulfide (CdS) or light dependent resistor (LDR) whose resistance is inversly dependent on the amount of light falling on it, is known by many names including the photo resistor, photoresistor, photoconductor, photoconductive cell, or simply the photocell.\n\nA typical structure for a photoresistor uses an active semiconductor layer that is deposited on an insulating substrate. The semiconductor is normally lightly doped to enable it to have the required level of conductivity. Contacts are then placed either side of the exposed area.\n\nThe photo-resistor, CdS, or LDR finds many uses as a low cost photo sensitive element and was used for many years in photographic light meters as well as in other applications such as smoke, flame and burglar detectors, card readers and lighting controls for street lamps.\n\nProviding design engineers with an economical CdS or LDR with high quality performance, Token Electronics now offers commercial grade PGM photoresistor. Designated the PGM Series, the photoresistors are available in 5mm, 12mm and 20mm sizes, the conformally epoxy or hermetical package offer high quality performance for applications that require quick response and good characteristic of spectrum.\n\nToken has been designing and manufacturing high performance light dependent resistors for decades. Our product offerings are extensive and our experience with custom photoresistor is equally extensive. Contact us with your specific needs.\n\n

PGM00000

MODEL LDD - LARGE DIGIT DISPLAY

PGM08

ARIES COLLET CONTACT PINS

PGM08XXX-XX

ARIES COLLET CONTACT PINS

PGM-1

PUSH GROMMET HOLE PLUG [M SERIES]

PGM-10

PUSH GROMMET HOLE PLUG [M SERIES]

PGM-11

PUSH GROMMET HOLE PLUG [M SERIES]

PGM-12

PUSH GROMMET HOLE PLUG [M SERIES]

PGM12XXX-XX

ARIES COLLET CONTACT PINS