PCA9509GM中文资料Level translating I2C-bus/SMBus repeater数据手册恩XP规格书

描述 Description

The PCA9509 is a level translating I²C-bus/SMBus repeater that enables processor lowvoltage 2-wire serial bus to interface with standard I²C-bus or SMBus I/O. While retainingall the operating modes and features of the I²C-bus system during the level shifts, it alsopermits extension of the I²C-bus by providing bidirectional buffering for both the data(SDA) and the clock (SCL) lines, thus enabling the I²C-bus or SMBus maximumcapacitance of 400 pF on the higher voltage side. Port A allows a voltage range from1.35 V to VCC(B) ‑ 1.0 V and requires no external pull-up resistors due to the internalcurrent source. Port B allows a voltage range from 3.0 V to 5.5 V and is overvoltagetolerant. Both port A and port B SDA and SCL pins are high-impedance when thePCA9509 is unpowered.
For applications where Port A VCC(A) is less than 1.35 V or Port B VCC(B) is less than 3.0 V,use drop-in replacement PCA9509A.
The bus port B drivers are compliant with SMBus I/O levels, while port A uses a currentsensing mechanism to detect the input or output LOW signal which prevents bus lock-up.Port A uses a 1 mA current source for pull-up and a 200 Ω pull-down driver. This results ina LOW on the port A accommodating smaller voltage swings. The output pull-down on theport A internal buffer LOW is set for approximately 0.2 V, while the input threshold of theinternal buffer is set about 50 mV lower than that of the output voltage LOW. When theport A I/O is driven LOW internally, the LOW is not recognized as a LOW by the input.This prevents a lock-up condition from occurring. The output pull-down on the port Bdrives a hard LOW and the input level is set at 0.3 of SMBus or I²C-bus voltage levelwhich enables port B to connect to any other I²C-bus devices or buffer.
The PCA9509 drivers are not enabled unless VCC(A) is above 0.8 V and VCC(B) is above2.5 V. The enable (EN) pin can also be used to turn on and turn off the drivers undersystem control. Caution should be observed to change only the state of the EN pin whenthe bus is idle.

特性 Features

Bidirectional buffer isolates capacitance and allows 400 pF on port B of the device
Voltage level translation from port A (1.35 V to VCC(B) ‑ 1.0 V) to port B (3.0 V to 5.5 V)
Requires no external pull-up resistors on lower voltage port A
Active HIGH repeater enable input
Open-drain inputs/outputs
Lock-up free operation
Supports arbitration and clock stretching across the repeater
Accommodates Standard-mode and Fast-mode I²C-bus devices and multiple masters
Powered-off high-impedance I²C-bus pins
Operating supply voltage range of 1.35 V to VCC(B) ‑ 1.0 V on port A, 3.0 V to 5.5 V onport B
5 V tolerant port B SCL, SDA and enable pins
0 Hz to 400 kHz clock frequency
Remark: The maximum system operating frequency may be less than 400 kHz because of the delays added by the repeater.
ESD protection exceeds 2000 V HBM per JESD22-A114 and 1000 V CDM per JESD22-C101
Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA
Packages offered: TSSOP8, SO8, XQFN8