P87C54X2BN中文资料80C51 8-bit microcontroller family数据手册恩XP规格书

描述 Description

Overview The Philips microcontrollers described in this data sheet are high-performance static 80C51 designs incorporating Philips? high-density CMOS technology with operation from 2.7 V to 5.5 V. They support both 6-clock and 12-clock operation.
The P8xC31X2/51X2 and P8xC32X2/52X2/54X2/58X2 contain 128 byte RAM and 256 byte RAM respectively, 32 I/O lines, three 16-bit counter/timers, a six-source, four-priority level nested interrupt structure, a serial I/O port for either multi-processor communications, I/O expansion or full duplex UART, and on-chip oscillator and clock circuits.
In addition, the devices are low power static designs which offer a wide range of operating frequencies down to zero. Two software selectable modes of power reduction ? idle mode and power-down mode ? are available. The idle mode freezes the CPU while allowing the RAM, timers, serial port, and interrupt system to continue functioning. The power-down mode saves the RAM contents but freezes the oscillator, causing all other chip functions to be inoperative. Since the design is static, the clock can be stopped without loss of user data. Then the execution can be resumed from the point the clock was stopped.

特性 Features

80C51 Central Processing Unit 4 kbytes ROM/EPROM (P80/P87C51X2)
8 kbytes ROM/EPROM (P80/P87C52X2)
16 kbytes ROM/EPROM (P80/P87C54X2)
32 kbytes ROM/EPROM (P80/P87C58X2)
128 byte RAM (P80/P87C51X2 and P80C31X2)
256 byte RAM (P80/P87C52/54X2/58X2 and P80C32X2)
Boolean processor
Fully static operation
Low voltage (2.7 V to 5.5 V at 16 MHz) operation

12-clock operation with selectable 6-clock operation (via software or via parallel programmer)
Memory addressing capability Up to 64 kbytes ROM and 64 kbytes RAM

Power control modes: Clock can be stopped and resumed
Idle mode
Power-down mode

CMOS and TTL compatible
Two speed ranges at VCC = 5 V 0 to 30 MHz with 6-clock operation
0 to 33 MHz with 12-clock operation

PLCC, DIP, TSSOP or LQFP packages
Extended temperature ranges
Dual Data Pointers
Security bits: ROM (2 bits)
OTP (3 bits)

Encryption array - 64 bytes
Four interrupt priority levels
Six interrupt sources
Four 8-bit I/O ports
Full-duplex enhanced UART Framing error detection
Automatic address recognition

Three 16-bit timers/counters T0, T1 (standard 80C51) and additional T2 (capture and compare)
Programmable clock-out pin
Asynchronous port reset
Low EMI (inhibit ALE, slew rate controlled outputs, and 6-clock mode)
Wake-up from Power Down by an external interrupt.