OPAx835 Ultra-Low-Power, Rail-to-Rail Out, Negative Rail In, VFB Op Amp

1 Features • Ultra-Low Power – Supply Voltage: 2.5 V to 5.5 V – Quiescent Current: 250 μA/ch (Typical) – Power Down Mode: 0.5 μA (Typical) • Bandwidth: 56 MHz (AV = 1 V/V) • Slew Rate: 160 V/μs • Rise Time: 10 ns (2 VSTEP) • Settling Time (0.1%): 55 ns (2 VSTEP) • Overdrive Recovery T

文件：2.86391 Mbytes 页数：63 Pages

TI

德州仪器

OPAx836 Very-Low-Power, Rail-to-Rail Out, Negative Rail In, Voltage-Feedback Operational Amplifiers

1 Features • Low Power: – Supply Voltage: 2.5 V to 5.5 V – Quiescent Current: 1 mA (Typical) – Power Down Mode: 0.5 μA (Typical) • Bandwidth: 205 MHz • Slew Rate: 560 V/μs • Rise Time: 3 ns (2 VSTEP) • Settling Time (0.1%): 22 ns (2 VSTEP) • Overdrive Recovery Time: 60 ns • SNR: 0.00

文件：2.96303 Mbytes 页数：66 Pages

TI

德州仪器

OPA838 1mA, 300MHz Gain Bandwidth, Voltage-Feedback Op Amp

1 Features • Gain bandwidth product: 300MHz • Very-low (trimmed) supply current: 950μA • Bandwidth: 90MHz (AV = 6V/V) • High full-power bandwidth: 45MHz, 4VPP • Negative rail input, rail-to-rail output • Single-supply operating range: 2.7V to 5.4V • 25°C input offset: ±125μV (maximum) • In

文件：3.44709 Mbytes 页数：54 Pages

TI

德州仪器

Very Low-Power, Rail-to-Rail Out, Negative Rail In, VFB Op Amp

文件：1.76547 Mbytes 页数：49 Pages

TI

德州仪器

Very-Low Power, Rail-to-Rail Out, Negative-Rail In, Voltage-Feedback Operational Amplifier

文件：1.30215 Mbytes 页数：44 Pages

TI

德州仪器

Very Low-Power, Rail-to-Rail Out, Negative Rail In, VFB Op Amp

文件：2.06858 Mbytes 页数：54 Pages

TI

德州仪器

双路、超低功耗、轨到轨输出、负轨输入、VFB 运算放大器

OPA836 和 OPA2836 器件 (OPAx836) 为单通道和双通道超低功耗、轨至轨输出、负电源轨输入、电压反馈 (VFB) 运算放大器，依设计可由 2.5V 至 5.5V 范围内的单电源或者 ±1.25V 至 ±2.75V 范围内的双电源供电运行。这些轨至轨放大器每通道仅消耗 1mA 的电流，单位增益带宽为 205MHz，功耗/性能比处于先进水平。\n\nOPA836 和 OPA2836 器件同时拥有低功耗特性和出色的高频性能，并且可提供其他同类器件所无法达到的性能/功耗比，因此非常适合注重功耗的电池供电类便携式应用。这些器件还具有节能模式，可将电流降至 1.5µA 以下，这对于电池 • 低功耗： \n• 静态电流：1mA（典型值）\n• 带宽：205MHz\n• 上升时间：3ns (2VSTEP)\n• 过驱恢复时间：60ns\n• THD：在 1kHz (1VRMS) 时为 0.00003% (-130dBc)\n• 输入电压噪声：4.6nV/√ Hz (f = 100kHz)\n• CMRR：116dB\n• RRO：轨到轨输出\n• 工作温度范围：–40°C 至 +125°C;

TI

德州仪器

丝印：2836；Package：SOIC(D)；OPAx836 Very-Low-Power, Rail-to-Rail Out, Negative Rail In, Voltage-Feedback Operational Amplifiers

1 Features • Low Power: – Supply Voltage: 2.5 V to 5.5 V – Quiescent Current: 1 mA (Typical) – Power Down Mode: 0.5 μA (Typical) • Bandwidth: 205 MHz • Slew Rate: 560 V/μs • Rise Time: 3 ns (2 VSTEP) • Settling Time (0.1%): 22 ns (2 VSTEP) • Overdrive Recovery Time: 60 ns • SNR: 0.00

文件：2.96303 Mbytes 页数：66 Pages

TI

德州仪器

丝印：2836；Package：SOIC(D)；OPAx836 Very-Low-Power, Rail-to-Rail Out, Negative Rail In, Voltage-Feedback Operational Amplifiers

1 Features • Low Power: – Supply Voltage: 2.5 V to 5.5 V – Quiescent Current: 1 mA (Typical) – Power Down Mode: 0.5 μA (Typical) • Bandwidth: 205 MHz • Slew Rate: 560 V/μs • Rise Time: 3 ns (2 VSTEP) • Settling Time (0.1%): 22 ns (2 VSTEP) • Overdrive Recovery Time: 60 ns • SNR: 0.00

文件：2.96303 Mbytes 页数：66 Pages

TI

德州仪器

丝印：2836；Package：VSSOP(DGS)；OPAx836 Very-Low-Power, Rail-to-Rail Out, Negative Rail In, Voltage-Feedback Operational Amplifiers

1 Features • Low Power: – Supply Voltage: 2.5 V to 5.5 V – Quiescent Current: 1 mA (Typical) – Power Down Mode: 0.5 μA (Typical) • Bandwidth: 205 MHz • Slew Rate: 560 V/μs • Rise Time: 3 ns (2 VSTEP) • Settling Time (0.1%): 22 ns (2 VSTEP) • Overdrive Recovery Time: 60 ns • SNR: 0.00

文件：2.96303 Mbytes 页数：66 Pages

TI

德州仪器