MC145583

3.3 VOLT ONLY DRIVER / RECEIVER WITH AN INTEGRATED STANDBY MODE

3.3VoltOnlyDriver/ReceiverwithanIntegratedStandbyModeEIA–232–EandCCITTV.28 TheMC145583isaCMOStransceivercomposedofthreedriversandfivereceiversthatfulfillstheelectricalspecificationsofEIA–232–E,EIA–562,andCCITTV.28whileoperatingfromasingle+3.3or+5.0Vp

MC145583

3.3 V - 5.0 V EIA-232/V.28 CMOS Driver/Receiver, 3 x 5; Drivers\n\n\t•+/- 5 V Minimum Output Swing at 3.3 or 5.0 V Power Supply\n\t•300 ohm Power-Off Impedance\n\t•Output Current Limiting\n\t•Three-State Outputs During Standby Mode\n\nReceivers\n\n\t•+/- 25 V Input Range\n\t•3 to 7 k ohm Input Impedance\n\t•0.8 V Hysteresis for Enhanced Noise Immunity\n\t•Three-State Outputs During Standby Mode\n\nRing Monitor Circuit\n\n\t•Invert the Input Level on Rx1 to Logic Output Level on RIMON at Standby Mode\n;

Overview The MC145583 has been discontinued. Suggested replacement: none.The MC145583 is a CMOS transceiver composed of three drivers and five receivers that fulfillsthe electrical specifications of EIA-232-E, EIA-562, and CCITT V.28 while operating from a single3.3 or 5.0 V power supply. This transceiver is a high-performance, low-power consumption devicethat is equipped with a standby function. A voltage tripler and inverter converts the 3.3 V to +/- 8.8 V, or a voltage doubler andinverter converts the 5.0 V to +/- 8.8 V. This is accomplished through an on-chip 40 kHz oscillatorand five inexpensive external capacitors.

MC145583

3.3 Volt Only Driver/Receiver with an Integrated Standby Mode RS 232/EIA-232-E and CCITT V.28;

MC145583DW

3.3 VOLT ONLY DRIVER / RECEIVER WITH AN INTEGRATED STANDBY MODE

3.3VoltOnlyDriver/ReceiverwithanIntegratedStandbyModeEIA–232–EandCCITTV.28 TheMC145583isaCMOStransceivercomposedofthreedriversandfivereceiversthatfulfillstheelectricalspecificationsofEIA–232–E,EIA–562,andCCITTV.28whileoperatingfromasingle+3.3or+5.0Vp

MC145583DW

3.3 VOLT ONLY DRIVER / RECEIVER WITH AN INTEGRATED STANDBY MODE

TheMC14529Banalogdataselectorisadual4–channelorsingle8–channeldevicedependingontheinputcoding.Thedeviceissuitablefordigitalaswellasanalogapplication,includingvariousone–of–fourandone–of–eightdataselectorfunctions.Sincethedevicehasbidirectionalanalogcharac

MC145583DW

3.3 Volt Only Driver/Receiver with an Integrated Standby Mode RS 232/EIA-232-E and CCITT V.28

LegacyDevice:MotorolaMC145583 TheML145583isaCMOStransceivercomposedofthreedriversandfivereceiversthatfulfillstheelectricalspecificationsofEIA–232–E,EIA–562,andCCITTV.28whileoperatingfromasingle+3.3or+5.0Vpowersupply.Thistransceiverisahigh–performance,l

MC145583VF

3.3 VOLT ONLY DRIVER / RECEIVER WITH AN INTEGRATED STANDBY MODE

3.3VoltOnlyDriver/ReceiverwithanIntegratedStandbyModeEIA–232–EandCCITTV.28 TheMC145583isaCMOStransceivercomposedofthreedriversandfivereceiversthatfulfillstheelectricalspecificationsofEIA–232–E,EIA–562,andCCITTV.28whileoperatingfromasingle+3.3or+5.0Vp

MC145583VF

3.3 VOLT ONLY DRIVER / RECEIVER WITH AN INTEGRATED STANDBY MODE

TheMC14529Banalogdataselectorisadual4–channelorsingle8–channeldevicedependingontheinputcoding.Thedeviceissuitablefordigitalaswellasanalogapplication,includingvariousone–of–fourandone–of–eightdataselectorfunctions.Sincethedevicehasbidirectionalanalogcharac

MC145583DW

3.3 Volt Only Driver/Receiver with an Integrated Standby Mode RS 232/EIA-232-E and CCITT V.28;

MC145583DW

3.3 Volt Only Driver/Receiver