MC10E137中文资料ECL 8-Bit Ripple Counter数据手册ONSEMI规格书

描述 Description

The MC10E/100E137 is a very high speed binary ripple counter. The two least significant bits were designed with very fast edge rates while the more significant bits maintain standard ECLinPS output edge rates. This allows the counter to operate at very high frequencies while maintaining a moderate power dissipation level.The device is ideally suited for multiple frequency clock generation as well as a counter in a high performance ATE time measurement board. Both asynchronous and synchronous enables are available to maximize the device's flexibility for various applications. The asynchronous enable input, A_Start, when asserted enables the counter while overriding any synchronous enable signals. The E137 features XORed enable inputs, EN1 and EN2, which are synchronous to the CLK input. When only one synchronous enable is asserted the counter becomes disabled on the next CLK transition; all outputs remain in the previous state poised for the other synchronous enable or A_Start to be asserted to re-enable the counter. Asserting both synchronous enables causes the counter to become enabled on the next transition of the CLK.If EN1 (or EN2) and CLK edges are coincident, sufficient delay has been inserted in the CLK path (to compensate for the XOR gate delay and the internal D-flip flop setup time) to insure that the synchronous enable signal is clocked correctly, hence, the counter is disabled. The E137 can also be driven single-endedly utilizing the VBB output supply as the voltage reference for the CLK input signal.If a single-ended signal is to be used the VBB pin should be connected to the CLKbar input and MR bypassed to ground via a 0.01 uF capacitor. VBB can only source/sink 0.5mA, therefore it should be used as a switching reference for the E137 only. All input pins left open will be pulled LOW via an input pulldown resistor. Therefore, do not leave the differential CLK inputs open. Doing so causes the current source transisto

特性 Features

• Differential Clock Input and Data Output Pins
• VBB Output for Single-Ended Use
• Synchronous and Asynchronous Enable Pins
• Asynchronous Master Reset
• PECL Mode Operating Range: VCC = 4.2 V to 5.7 V with VEE = 0 V
• NECL Mode Operating Range: VCC = 0 V with VEE = -4.2 V to -5.7 V
• Internal Input Pulldown Resistors
• ESD Protection: > 2 KV HBM, > 100 V MM
• Meets or Exceeds JEDEC Spec EIA/JESD78 IC Latchup Test
• Moisture Sensitivity Level 1For Additional Information, see Application Note AND8003/D
• Flammability Rating: UL-94 code V-0 @ 1/8\", Oxygen Index 28 to 34
• Transistor Count = 330 devices
• Pb-Free Packages are Available

简介

MC10E137属于集成电路（IC）的计数器除法器。由制造生产的MC10E137计数器，除法器计数器和除法器 IC 是数字逻辑器件，可对输入发生的逻辑转换进行计数，然后使用多个并行输出重新发送累加的计数，和/或生成单个输出信号转换，从而对应用某些整数数量输入信号转换进行响应。除了简单的事件计数，它们还可用于各种频率合成应用。