MB84VD21084EM-70PBS中文资料飞索数据手册PDF规格书

■ FEATURES

• Power Supply Voltage of 2.7 V to 3.3 V

• High Performance

70 ns maximum access time (Flash)

70 ns maximum access time (SRAM)

• Operating Temperature

–40 °C to +85 °C

• Package 56-ball BGA

● FLASH MEMORY

• Simultaneous Read/Write Operations (Dual Bank)

Miltiple devices available with different bank sizes (Please refer to ORDERING INFORMATION)

Host system can program or erase in one bank, then immediately and simultaneously read from the other bank

Zero latency between read and write operations

Read-while-erase

Read-while-program

• Minimum 100,000 Write/Erase Cycles

• Sector Erase Architecture

Eight 4 K words and thirty one 32 K words.

Any combination of sectors can be concurrently erased. Also supports full chip erase.

• Boot Code Sector Architecture

MB84VD2108XEM: Top sector

MB84VD2109XEM: Bottom sector

• Embedded EraseTM* Algorithms

Automatically pre-programs and erases the chip or any sector

• Embedded ProgramTM* Algorithms

Automatically writes and verifies data at specified address

• Data Polling and Toggle Bit Feature for Detection of Program or Erase Cycle Completion

• Ready-Busy Output (RY/BY)

Hardware method for detection of program or erase cycle completion

• Automatic Sleep Mode

When addresses remain stable, automatically switch themselves to low power mode.

• Low VCC Write Inhibit ≤ 2.5 V

• HiddenROM Region

64K byte of HiddenROM, accessible through a new “HiddenROM Enable” command sequence

Factory serialized and protected to provide a secure electronic serial number (ESN)

• WP/ACC Input Pin

At VIL, allows protection of boot sectors, regardless of sector protection/unprotection status

(MB84VD2108XEM:SA37,SA38 MB84VD2109XEM:SA0,SA1)

At VIH, allows removal of boot sector protection

At VACC, program time will reduse by 40.

• Erase Suspend/Resume

Suspends the erase operation to allow a read in another sector within the same device

• Please refer to “MBM29DL16XTE/BE” Datasheet in Detailed Function

● SRAM

• Power Dissipation

Operating : 40 mA Max

Standby : 7 µA Max

• Power Down Features using CE1s and CE2s

• Data Retention Supply Voltage: 1.5 V to 3.3 V

• CE1s and CE2s Chip Select

• Byte Data Control: LB (DQ7 to DQ0), UB (DQ15 to DQ8)