5.5W 2-Channel AF Power Amplifier

Features • Dual channels. Output : 5.5W×2 (typ.) • Minimun number of external parts required. • Small pop noise at the time of power supply ON/OFF and good starting balance. • Good ripple rejection : 46dB (typ.) • Good channel separation. • Small residual noise (Rg=0). • Bu

文件：211.5 Kbytes 页数：7 Pages

SANYO

三洋

5.5W 2-Channel AF Power Amplifier

• Dual channels.\nOutput : 5.5W×2 (typ.)\n• Minimun number of external parts required.\n• Small pop noise at the time of power supply ON/OFF and good starting balance.\n• Good ripple rejection : 46dB (typ.)\n• Good channel separation.\n• Small residual noise (Rg=0).\n• Built-in protectors.\n  a. The;

ONSEMI

安森美半导体

Fully Assembled and Tested Surface-Mount Board

文件：97.63 Kbytes 页数：4 Pages

MAXIM

美信

Ultra-High-Speed, Low-Distortion, Differentialto- Single-Ended Line Receivers with Enable

General Description The MAX4444/MAX4445 differential line receivers offer unparalleled high-speed, low-distortion performance. Using a three op amp instrumentation amplifier architecture, these ICs have symmetrical differential inputs and a single-ended output. They operate from ±5V supplies an

文件：87.29 Kbytes 页数：8 Pages

MAXIM

美信

Ultra-High-Speed, Low-Distortion, Differentialto- Single-Ended Line Receivers with Enable

Features © 5000V/μs Slew Rate (MAX4444) © +2V/V Internally Fixed Gain (MAX4444) © External Gain Selection (MAX4445, AVCL ³ +2V/V) © 550MHz -3dB Bandwidth © -60dB SFDR at 5MHz © Low Differential Gain/Phase: 0.07%/0.05° © Low Noise: 25nV/ÃHz at fIN = 100kHz © Low-Power Disable Mode Redu

文件：95.38 Kbytes 页数：8 Pages

AD

亚德诺