Quad Power Drivers with Serial Diagnostic Interface

Description The HIP0082 and HIP0084 Quad Power Drivers contain four individually protected NDMOS transistor switches to drive inductive and resistive loads such as: fuel injectors, relays, solenoids, etc. The outputs are low-side switches driven by active-low CMOS logic inputs. Each output is pro

文件：90.94 Kbytes 页数：12 Pages

Intersil

Quad Power Drivers with Serial Diagnostic Interface

Features •Low Side Power MOSFET Output Drivers -Output Voltage Clamp (Typ). . . . . . . . . . . . . . . . . 80V -Maximum Output Current . . . . . . . . . . . . . . . . 5A/2A -Output rDS(ON) (TJ = 150oC) (Max) . . . . 0.57/0.62 •Controlled Slew Rate Switching (HIP0084) •Single Pulse Energy

文件：1.06231 Mbytes 页数：11 Pages

RENESAS

瑞萨

Quad Power Drivers with Serial Diagnostic Interface

Features •Low Side Power MOSFET Output Drivers -Output Voltage Clamp (Typ). . . . . . . . . . . . . . . . . 80V -Maximum Output Current . . . . . . . . . . . . . . . . 5A/2A -Output rDS(ON) (TJ = 150oC) (Max) . . . . 0.57/0.62 •Controlled Slew Rate Switching (HIP0084) •Single Pulse Energy

文件：1.06231 Mbytes 页数：11 Pages

RENESAS

瑞萨

Quad Power Drivers with Serial Diagnostic Interface

Description The HIP0082 and HIP0084 Quad Power Drivers contain four individually protected NDMOS transistor switches to drive inductive and resistive loads such as: fuel injectors, relays, solenoids, etc. The outputs are low-side switches driven by active-low CMOS logic inputs. Each output is pro

文件：90.94 Kbytes 页数：12 Pages

Intersil

Quad Power Drivers with Serial Diagnostic Interface

Description The HIP0082 and HIP0084 Quad Power Drivers contain four individually protected NDMOS transistor switches to drive inductive and resistive loads such as: fuel injectors, relays, solenoids, etc. The outputs are low-side switches driven by active-low CMOS logic inputs. Each output is pro

文件：90.94 Kbytes 页数：12 Pages

Intersil

Quad Power Drivers with Serial Diagnostic Interface

Features •Low Side Power MOSFET Output Drivers -Output Voltage Clamp (Typ). . . . . . . . . . . . . . . . . 80V -Maximum Output Current . . . . . . . . . . . . . . . . 5A/2A -Output rDS(ON) (TJ = 150oC) (Max) . . . . 0.57/0.62 •Controlled Slew Rate Switching (HIP0084) •Single Pulse Energy

文件：1.06231 Mbytes 页数：11 Pages

RENESAS

瑞萨

Quad Power Drivers with Serial Diagnostic Interface

Features •Low Side Power MOSFET Output Drivers -Output Voltage Clamp (Typ). . . . . . . . . . . . . . . . . 80V -Maximum Output Current . . . . . . . . . . . . . . . . 5A/2A -Output rDS(ON) (TJ = 150oC) (Max) . . . . 0.57/0.62 •Controlled Slew Rate Switching (HIP0084) •Single Pulse Energy

文件：1.06231 Mbytes 页数：11 Pages

RENESAS

瑞萨

Quad Power Drivers with Serial Diagnostic Interface

Description The HIP0082 and HIP0084 Quad Power Drivers contain four individually protected NDMOS transistor switches to drive inductive and resistive loads such as: fuel injectors, relays, solenoids, etc. The outputs are low-side switches driven by active-low CMOS logic inputs. Each output is pro

文件：90.94 Kbytes 页数：12 Pages

Intersil

0.3A/50V Octal Low Side Power Driver with Serial Bus Control and Over-Current Fault Flag

Description The HIP0050 is a logic controlled, eight channel Octal Low Side Power Driver. As shown in the block diagram, the outputs are controlled via the serial data interface which allows the data to be shifted out, allowing control of other cascaded serial devices. If an Over-Current (OC) sho

文件：45.98 Kbytes 页数：7 Pages

Intersil

0.3A/50V Octal Low Side Power Driver withSerial Bus Control and Over-Current Fault Flag

Features • Octal NDMOS Output Drivers in a High Voltage Power BiMOS Process - Each Capable of Sinking 300mA - Low Idle and Standby Current • Over-Stress Protection - Each Output: - Over-Current Latch Off . . . . . . . . . 300mA Min - Over-Voltage Clamp . . . . . . . . . . . . . . . 50V Typ

文件：456.74 Kbytes 页数：7 Pages

RENESAS

瑞萨