DSP56374UM中文资料摩托罗拉数据手册PDF规格书

Overview

The DSP56374 is a high density CMOS device with 3.3 V inputs and outputs.

The DSP56374 supports digital audio applications requiring sound field processing, acoustic equalization, and other digital audio algorithms. The DSP56374 uses the high performance, single-clock-per-cycle DSP56300 core family of programmable CMOS digital signal processors (DSPs) combined with the audio signal processing capability of the Freescale Semiconductor, Inc. (formerly Motorola) Symphony™ DSP family, as shown in Figure 1.

特性 Features

1.1 DSP56300 Modular Chassis

• 150 Million Instructions Per Second (MIPS) with a 150 MHz clock at an internal logic supply (QVDDL) of 1.25 V.

• Object Code Compatible with the 56K core.

• Data ALU with a 24 x 24 bit multiplier-accumulator and a 56-bit barrel shifter;16 bit arithmatic support.

• Program Control with position independent code support.

• Six-channel DMA controller.

• Provides a wide range of frequency multiplications (1 to 255), predivider factors (1 to 31), PLL feedback multiplier (2 or 4), Output divide factor (1, 2 or 4) and a power-saving clock divider (2i: i = 0 to 7) to reduce clock noise

• Internal address tracing support and OnCE for Hardware/Software debugging.

• JTAG port, supporting boundary scan, compliant to IEEE 1149.1.

• Very low-power CMOS design, fully static design with operating frequencies down to DC.

• STOP and WAIT low-power standby modes.

1.2 On-chip Memory Configuration

• 6Kx24 Bit Y-Data RAM and 4Kx24 Bit Y-Data ROM.

• 6Kx24 Bit X-Data RAM and 4Kx24 Bit X-Data ROM.

• 20Kx24 Bit Program and Bootstrap ROM including a PROM patching mechanism.

• 6Kx24 Bit Program RAM.

• Various memory switches are available. See memory table below.

1.3 Peripheral modules

• Enhanced Serial Audio Interface (ESAI): up to 4 receiver pins and up to 6 transmitter pins, master or slave. I2S, Sony, AC97, network and other programmable protocols.

• Enhanced Serial Audio Interface I (ESAI_1): up to 4 receiver pins and up to 6 transmitter pins, master or slave. I2S, Sony, AC97, network and other programmable protocols. Note: Available in the 80 pin package only

• Serial Host Interface (SHI): SPI and I2C protocols, 10-word receive FIFO, support for 8, 16 and 24-bit words. Three noise reduction filter modes.

• Triple Timer module (TEC).

• Most pins of unused peripherals may be programmed as GPIO pins. Up to 47 pins can be configured as GPIO on the 80 pin package and 20 pins on the 52 pin package.

• Hardware Watchdog Timer