CD74HC195E.A中文资料德州仪器数据手册PDF规格书

Features

• Asynchronous Master Reset

• J, K, (D) Inputs to First Stage

• Fully Synchronous Serial or Parallel Data Transfer

• Shift Right and Parallel Load Capability

• Complementary Output From Last Stage

• Buffered Inputs

• Typical fMAX = 50MHz at VCC = 5V,

CL = 15pF, TA = 25oC

• Fanout (Over Temperature Range)

- Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads

- Bus Driver Outputs . . . . . . . . . . . . . 15 LSTTL Loads

• Wide Operating Temperature Range . . . -55oC to 125oC

• Balanced Propagation Delay and Transition Times

• Significant Power Reduction Compared to LSTTL

Logic ICs

• HC Types

- 2V to 6V Operation

- High Noise Immunity: NIL = 30%, NIH = 30%of VCC at

VCC = 5V

Description

The device is useful in a wide variety of shifting, counting

and storage applications. It performs serial, parallel, serial to

parallel, or parallel to serial data transfers at very high

speeds.

The two modes of operation, shift right (Q0-Q1) and parallel

load, are controlled by the state of the Parallel Enable (PE)

input. Serial data enters the first flip-flop (Q0) via the J and K

inputs when the PE input is high, and is shifted one bit in the

direction Q0-Q1-Q2-Q3 following each Low to High clock

transition. The J and K inputs provide the flexibility of the JKtype

input for special applications and by tying the two pins

together, the simple D-type input for general applications.

The device appears as four common-clocked D flip-flops

when the PE input is Low. After the Low to High clock

transition, data on the parallel inputs (D0-D3) is transferred

to the respective Q0-Q3 outputs. Shift left operation (Q3-Q2)

can be achieved by tying the Qn outputs to the Dn-1 inputs

and holding the PE input low.

All parallel and serial data transfers are synchronous, occurring

after each Low to High clock transition. The ’HC195 series

utilizes edge triggering; therefore, there is no restriction on the

activity of the J, K, Pn and PE inputs for logic operations, other

than set-up and hold time requirements. A Low on the

asynchronous Master Reset (MR) input sets all Q outputs Low,

independent of any other input condition.