BX24P4L

Hazardous Area Limit Switches; ·cULus, ATEX (CE), IEC Ex, INMETRO, NEPSI, EAC (Gost-R) approvals\n·Sealing - applicable portions of IP67 and NEMA 1, 3, 4, 4X, 6 and 13\n·316L Stainless steel housing for protection in highly corrosive and/or caustic environments\n·Diverse conduit selection for wide range of applications\n·Compatible with LSX\n·Variety of heads and non-sparking actuators\n·10 A continuous carry electrical rating\n·Choice of silver or gold contacts\n·Internal grounding screw;

MICRO SWITCH BX2 Series Hazardous Location Limit Switches (Non Plug-in), side rotary (momentary, low PT and DT), 2NC 2NO SPDT snap action, 20 mm conduit, and 316L stainless steel housing.The MICRO SWITCH BX2 Series features a 316L stainless steel enclosure that provides enhanced corrosion resistance in applications exposted to aggressive, caustic agents. The stainless steel housing helps protect the switch mechanism from corrosion often present in chemical processing plants, off-shore/near-shore sites, and other hazardous areas. These enclosures also meet the European Hazardous Locations Designation: II 2 GD, Ex d IIC T6 Gb; 1 Ex d IIC T6 Gb; II 2 D Ex tb IIIC t85C Db. The BX2 Series complies with the European Directive on Equipment and Protective Systems Intended for Use in Potentially Explosive Atmospheres (94/9/EC) commonly referred to as the ATEX Directive. Compliance with the Essential Health and Safety Requirements has been assured by compliance with EN50014 1997 and EN50018 1994. MICRO SWITCH BX2 Series meets the North American Hazardous Locations Designation: Division I, Class I, Groups B, C and D; Division I, Class II, Groups E, F and G and comply with UL Standard: UL 894, CSA Standard: C22.2 No. 25-1966, C22.2 No. 30-M1986 certifications. The MICRO SWITCH BX2 is ideal for outdoor use or in adverse environments where a combination of explosion proof plus sealing requirements are needed. To comply with explosion proof requirements the BX2 has flame paths within the housing, which cool exploding gases below the ignition temperature before they reach explosive gases surrounding the housing. Flame paths on the BX2 are \n an extended plunger between the switch cavity and head and (2) the cover-housing threads on the front of the switch.

BX24P4L

MICRO SWITCH BX/BX2 SERIES