Illuminative Touchpad Module

The capacitive touch pad sensor is covered with a plastic case.  The typical thickness of the plastic is less than 2.0mm.  It can also auto calibrate the parameters for a wide range of capacitance on the touch pad sensor (5pF~15pF).  The system controller converts finger position data to button pres Operating voltage: 3.0V ~ 5.5V, Ripple < 100mVpp.\nPower-on reset time: Stable time for operating < 400ms, the touch pad will send ¨Packet Hello〃 after initialization.\nInterface features: Serial Peripheral Interface (SPI- Slave) / I2C-Slave / I/O Mode.\nApplication mode: Support 32 buttons\n Suppor;

Elan

义隆

RF AMPLIFIER

文件：69.49 Kbytes 页数：1 Pages

APITECH

CK ROTARY SWITCH

FEATURES Standard 30° indexing, 60° and 90° available Moulded 27.5mm diameter Single wafer switch Maximum 12 positions Up to 4 poles per switch Shorting (make before break 30° indexing only) or non-shorting (break before make) Moulded stop or adjustable stops to restrict number of posit

文件：922.87 Kbytes 页数：4 Pages

ETCList of Unclassifed Manufacturers

未分类制造商

Power Amplifier/Antenna Switch Low Noise Down Conversion Mixer for PHS

文件：121.08 Kbytes 页数：7 Pages

SONYSony Corporation

索尼