4-channel linear driver IC for CD/CD-ROM drive

■ Overview The AN8783SB employs one channel of power op-amp. system and three channels of H-bridge system. Two channels out of three channels of H bridge method are a current feedback system. So this IC is optimum for driving an actuator and a motor of CD/CD-ROM drive. It comes with a surface m

文件：57.78 Kbytes 页数：7 Pages

Panasonic

松下

4-channel linear driver IC for CD/CD-ROM drive

■ Overview\nThe AN8783SB employs one channel of power op-amp. system and three channels of H-bridge system. Two channels out of three channels of H bridge method are a current feedback system. So this IC is optimum for driving an actuator and a motor of CD/CD-ROM drive. It comes with a surface mount • Little phase delay due to current feedback system (2-channel for actuator)\n• 4 modes of forward, reverse rotations, braking and standby can be selected from channels for load ing motor (H-bridge method) by a digital signal from a microcomputer.\n• Wide output dynamic range regardless of refer enc;

Panasonic

松下

ARINC INTERFACE DEVICE 8-BIT PARALLEL DATA CONVERTED 429&561 SERIAL DATA OUT

DESCRIPTION The HI-8783, HI-8784, and HI-8785 are system components for interfacing 8 bit parallel data to an ARINC 429 bus. The HI-8783 is a logic device only and requires a separate line driver circuit, such as the HI-3182 or HI-8585. The HI-8784 and HI-8785 combine logic and line driver on o

文件：194.3 Kbytes 页数：9 Pages

HOLTIC

霍尔特

ARINC INTERFACE DEVICE 8 bit parallel data converted to 429 & 561 serial data out

文件：186.69 Kbytes 页数：9 Pages

HOLTIC

霍尔特

ARINC 429 & 561 INTERFACE DEVICE

文件：86.52 Kbytes 页数：10 Pages

HOLTIC

霍尔特