ADS52J65IRGCR.A中文资料德州仪器数据手册PDF规格书

1 Features

1• 16-Bit Resolution, Idle SNR: 80 dBFS

• 70 mW/Ch at 125 MSPS, 4-CH per Lane

• 45 mW/Ch at 62.5 MSPS, 8-CH per Lane

• Full-Scale Input: 2 VPP

• Full-Scale SNR: 78 dBFS at fin = 10 MHz

• Full-Scale SFDR: –85 dBc at fin = 10 MHz

• Analog Input –3 dB Bandwidth = 250 MHz

• Maximum Input Signal Frequency for 2 VPP Input

= 130 MHz

• Fast and Consistent Overload Recovery

• Advanced Digital Features

– Automatic DC Offset Correction

– Digital Average

• Digital I/Q Demodulator

– Fractional Decimation Filter M = 1 to 63 With

Increments of 0.25

– Data Output Rate Reduction After Decimation

– 64 mW/Ch at 80 MSPS and Decimation = 2

– On-Chip RAM With 32 Preset Profiles

• JESD204B Subclass 0, 1, and 2

– 2, 4, or 8 Channels per JESD Lane

– 10-Gbps JESD Interface

– Supports lane rate up to 12.8 Gbps for short

trace length (< 5 Inch)

• 64-Pin Non-Magnetic 9 × 9-mm Package

2 Applications

• Medical Imaging: Ultrasound, MRI

• High Frequency Ultrasound

• Non-Destructive Tests (NDT)

• Radar, Lidar, and Spectroscopy

• Digital Oscillscopes and Data Acquistion

• Flow cytometry, flow cytometer, Hematology

analyzer

3 Description

The 8-channel, 16-bit ADS52J65 analog-to-digital

converter (ADC) uses CMOS process and innovative

circuit techniques. It is designed to operate at low

power and give very high signal-to-noise ratio (SNR)

performance with a 2-Vpp full-scale input. The device

gives 80-dBFS idle SNR and 78-dBFS full-scale SNR

at 5 MHz. The large input bandwidth of 250 MHz

makes the device suitable for a wide range of

applications, such as high frequency medical

ultrasound, magnetic resonance imaging, multichannel

data acquisition, flow cytometry, flow

cytometer, and hematology analyzer. The ADC

integrates an internal reference trimmed to match

across devices.

ADS52J65 has advanced digital features, including a

digital I/Q demodulator with fractional decimation

filter. The ADC data from each channel is encoded

using an 8B to 10B format and is sent as a SerDes

data stream using current-mode logic (CML) output

buffers, as per the JESD204B standard. The ADC

data from all eight channels can be output over a

single CML buffer (1-lane SerDes) with the data rate

limited to a maximum of 12.8 Gbps. Using SerDes

outputs reduces the number of interface lines. This,

together with the low-power design, enables eight

channels to be packaged in a 9-mm × 9-mm VQFN

allowing high system integration densities. ADS52J65

also supports modes where all ADC data is sent over

four CML buffers (4-Lane SerDes), reducing the

SerDes data rate per lane for low-cost FPGAs.

The ADS52J65 is available in a non-magnetic VQFN

package that does not create any magnetic artifact.

The device is specified over –40°C to +85°C.