ADMV1017

24 GHz 至 29.5 GHz 的 5G 升频/降频转换器; • RF 输入/输出频率范围：24 GHz 至 29.5 GHz，将 n257、n258 和 n261 频段集成在一个尺寸内\n\n• 1.5 GHz RF 带宽\n\n• 两种升频转换模式\n• 从差分基带 I/Q 直接转换或单端复合 IF 到 RF 单边带升频转换\n\n\n\n\n• 两种降频转换模式\n• 从 RF 到差分基带 I/Q 直接转换\n\n• 镜像抑制降频转换或单端复合 IF\n\n\n\n\n• LO 双倍频器 (x2) 和四倍频器 (x4) 模式\n\n• 匹配的 50Ω RF 信号和 LO 端口\n\n• 温度补偿\n\n• 符合 3GPP 规范;

The ADMV1017 is a silicon germanium (SiGe), microwave, upconverter and downconverter optimized for 5G radio designs operating in the 24 GHz to 29.5 GHz frequency range.\n\n The upconverter offers two modes of frequency translation. The device is capable of direct conversion to radio frequency (RF) from differential baseband I/Q input signals, as well as single-sideband (SSB) upconversion from complex intermediate frequency (IF) inputs. Alternatively, the differential baseband I/Q input path can be disabled and a modulated, single-ended, complex IF signals from 3 GHz to 10.5 GHz can be fed to the IF path. These signals can then be upconverted to 24 GHz to 29.5 GHz while rejecting the unwanted sideband by typically better than 25 dBc. The serial port interface (SPI) provides adjustment of the quadrature phase to allow optimum sideband rejection. In addition, the SPI interface allows powering down the output envelope detector to reduce power consumption when carrier feed through optimization is not necessary.\n\n The downconverter offers two modes of frequency translation. The device is capable of direct quadrature demodulation to differential baseband I/Q output signals, as well as image rejection downconversion to a single-ended complex IF output carrier frequency. The differential baseband outputs can be dc-coupled. More typically, however, the I/Q outputs are ac-coupled with a sufficiently low high-pass corner frequency to ensure adequate demodulation accuracy. The I/Q baseband output common-mode voltage is programmable between 0.75 V and 2.15 V. The SPI interface provides fine adjustment of the quadrature phase to optimize I/Q demodulation performance. Alternatively, the baseband I/Q outputs can be disabled, and the I/Q signals can be passed through an on-chip, active balun to provide two, single-ended, complex IF outputs between 3 GHz and 10.5 GHz. When the device is used as an image rejecting down-converter, the unwanted image term is typically rejected to better than 25 dBc below the desired sideband. The ADMV1017 offers a square law power detector to allow monitoring of the power levels at the mixer inputs. The detector output provides closed-loop control of the RF digital step attenuator via an external automatic gain control (AGC) loop.\n\n The ADMV1017 upconverter and downconverter is housed in a compact, thermally enhanced, 9 mm × 8 mm, land grid array (LGA) package. The ADMV1017 operates over the −40°C to +95°C case temperature range. Throughout the figures in the data sheet, Rx means receiver and Tx means transmitter.\n\n APPLICATIONS\n\n5G applicationsPoint to point microwave radiosRadar and electronic warfare systemsInstrumentation and automatic test equipment (ATE)

ADMV1017

100MHz to 70GHz Linear-in-dB RMS Power Detector with 35dB Dynamic Range

ADMV1017-EVALZ

包装：散装 类别：开发板，套件，编程器 射频评估和开发套件，开发板 描述：ADMV1017 EVAL BOARD

AOZ1017

EZBuck??3ASimpleRegulator

GeneralDescription TheAOZ1017isahighefficiency,simpletouse,3Abuckregulator.TheAOZ1017worksfroma4.5Vto16Vinputvoltagerange,andprovidesupto3Aofcontinuousoutputcurrentwithanoutputvoltageadjustabledownto0.8V. TheAOZ1017comesinanSO-8packageandisrat

AOZ1017A

EZBuck™3ASimpleRegulator

GeneralDescription TheAOZ1017Aisahighefficiency,simpletouse,3A buckregulator.TheAOZ1017Aworksfroma4.5Vto16V inputvoltagerange,andprovidesupto3Aofcontinuous outputcurrentwithanoutputvoltageadjustabledownto 0.8V. TheAOZ1017AcomesinanSO-8packageandis

AOZ1017AI

EZBuck??3ASimpleRegulator

GeneralDescription TheAOZ1017isahighefficiency,simpletouse,3Abuckregulator.TheAOZ1017worksfroma4.5Vto16Vinputvoltagerange,andprovidesupto3Aofcontinuousoutputcurrentwithanoutputvoltageadjustabledownto0.8V. TheAOZ1017comesinanSO-8packageandisrat