ADG715

CMOS, Low Voltage Serially-Controlled, Octal SPST Switches

GENERALDESCRIPTION TheADG714/ADG715areCMOS,octalSPST(single-pole,single-throw)switchescontrolledviaeithera2-or3-wireserialinterface.Onresistanceiscloselymatchedbetweenswitchesandveryflatoverthefullsignalrange.Eachswitchconductsequallywellinbothdirectionsa

ADG715

CMOS、低压、I2C 兼容型接口、串行控制、八通道单刀单掷开关; • I2C兼容型接口\n\n• 2.7 V至5.5 V单电源供电\n\n• ±2.5 V双电源\n\n• 导通电阻：2.5 Ω\n\n• 导通电阻平坦度：0.6 Ω;

ADG715是一款互补性金属氧化物半导体(CMOS)、八通道单刀单掷(SPST)开关，通过一个双线式串行接口进行控制。开关之间的导通电阻匹配严格，并且在整个信号范围内，导通电阻曲线平坦。各开关在两个方向的导电性能相同，输入信号范围可扩展至电源电压范围。数据以8位形式写入这些器件，每一位对应一个通道。\n\n ADG715采用与I2C接口标准兼容的双线式串行接口。ADG715具有四个硬连线地址，通过两个外部地址引脚（A0和A1）可选。这些引脚允许用户设置7位从机地址的两个LSB。最多可将四个器件连接到总线。\n\n 上电时，所有开关均处于断开状态，内部寄存器为全零。\n\n 该器件具有低功耗和2.7 V至5.5 V的工作电压范围，因而适合许多应用。ADG715也可以采用±2.5 V双电源供电。ADG715采用24引脚TSSOP封装。\n\n 产品聚焦\n\n 双线式串行接口。 单电源/双电源供电。ADG714和ADG715的额定电源电压为3 V、5 V和±2.5 V。 低导通电阻，通常为2.5 Ω。 低泄漏。 上电复位。 24引脚TSSOP封装。

ADG715

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

ADG715BRU

CMOS, Low Voltage Serially-Controlled, Octal SPST Switches

GENERALDESCRIPTION TheADG714/ADG715areCMOS,octalSPST(single-pole,single-throw)switchescontrolledviaeithera2-or3-wireserialinterface.Onresistanceiscloselymatchedbetweenswitchesandveryflatoverthefullsignalrange.Eachswitchconductsequallywellinbothdirectionsa

ADG715_15

Serially Controlled, Octal SPST Switches

ADG715BRU

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

ADG715BRU

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

ADG715BRU-REEL

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

ADG715BRU-REEL7

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

ADG715BRUZ

CMOS, Low Voltage Serially Controlled, Octal SPST Switches