7580320中文资料图尔克数据手册PDF规格书

The isolating transducers IM12-AI01-1I-2IUHPR/24VDC transmit analog measured signals galvanically isolated. The devices are

suitable for operation in zone 2.

The 1-channel device has one input for the

operation of HART® 2-wire transducers as

well as active and passive HART® 2-wire

transmitters. Connection is via removable

screw terminals. The device can be powered

from a power bridge that also transmits a collective fault signal.

The device is equipped with a 4…20 mA input circuit and two 4…20 mA output circuits

(either as source or sink) or 1…5 V (source).

The input signal at input [I1] is transferred 1:1

to outputs [O1] and [O2] within a range of 3.8

mA…20.5 mA without interference (splitter operation). In addition, digital signals can also be

transmitted bidirectionally in accordance with

the HART® protocol. Digital HART® signals

are only transmitted to output [A1].

Wire-break (

22 mA) in the transducer circuit are output as

current < 3.5 mA/voltage < 0.875 V.

The devices have a green power LED (Pwr).

For each input circuit there is a red status

LED. An error in the input circuit causes the

red LED to flash according to NE44.

The device can be used in safety circuits up

to SIL2 (high and low demand according to

IEC 61508) and meets the requirements of

the NE21.

The device is equipped with removable screw

terminals

■ Splitter function

■ Input circuits monitored for wire break and

short circuit

■ Complete galvanic isolation

■ HART transparent

■ Removable screw terminals

■ Connector for power bridge incl. in delivery

■ ATEX use in Zone 2, cUL

■ SIL 2