7580230中文资料图尔克数据手册PDF规格书

The frequency transducer/pulse counter IM12-

FI01-2SF-2I-CPR/24VDC/CC transmits frequency signals up to 20,000 Hz galvanically

isolated. In addition, the input signals can be

monitored for slip. The devices are suitable for

operation in zone 2.

Each channel of the 2-channel device is

equipped with an input for connecting sensors in accordance with EN 60947-5-6 (NAMUR) or potential-free contacts. A current output (0/4…20 mA) is available on the output

side. The device can be powered from a power bridge that also transmits a collective fault

signal.

The device is parameterized via FDT and

IODD with a PC. The current output can be

set to 0/4…20 mA (source or sink optional). In

accordance with the parameterization (I1, I2,

I1 - I2 or I2 - I1), the input signals are output

as a 0/4…20 mA normalized current signal.

The devices have a green power LED (Pwr)

and a red LED to indicate internal faults. For

each input circuit there is a yellow and a red

status LED. A fault in the input circuit leads

to a flashing red LED according to NE44, an

internal error to a steady red LED. The fault

current can be adjusted to 21.5

mA.

The device can be used in safety circuits up to

SIL2 (high and low demand according to IEC

61508) and meets the requirements of NE21.

It is equipped with removable spring type terminals.

The device is equipped with removable

spring-type terminals.

■ Input circuits monitored for wire-break and

short-circuit

■ Parameterized via PC

■ Complete galvanic isolation

■ Removable spring type terminals

■ Power bridge (connector incl. in delivery)

■ ATEX use in Zone 2, cUL

■ SIL 2