74ALVC162334ADGG中文资料16-bit registered driver with inverted register enable and 30 Ohm termination resistors (3-state)数据手册Nexperia规格书

描述 Description

The 74ALVC162334A is a 16-bit universal bus driver. Data flow is controlled by active LOW output enable (OE), active LOW latch enable (LE), and clock input (CP).
When LE is LOW, the A to Y data flow is transparent. When LE is HIGH and CP is held at LOW or HIGH, the data is latched; on the LOW to HIGH transient of CP, the A data is stored in the latch/flip-flop.
The 74ALVC162334A is designed with 30 Ω series resistors in both HIGH or LOW output stages.
When OE is LOW, the outputs are active. When OE is HIGH, the outputs go to the high-impedance OFF-state. Operation of the OE input does not affect the state of the latch/flip-flop.
To ensure the high-impedance state during power-up or power-down, OE should be tied to VCC through a pull-up resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

特性 Features

• Wide supply voltage range of 1.2 V to 3.6 V
• Complies with JEDEC standard 8-1A
• CMOS low power consumption
• Direct interface with TTL levels
• Current drive: ±24 mA at 3.0 V
• MULTIBYTE flow-through standard pinout architecture
• Low inductance multiple VCC and GND pins for minimum noise and ground bounce
• Output drive capability 50 Ω transmission lines at 85 °C
• Integrated 30 Ω termination resistors
• Input diodes to accommodate strong drivers