6884196中文资料图尔克数据手册PDF规格书

The relay module DO60R-N is used for the

connection of non-intrinsically safe actuators

such as valves or indicator lights.

The outputs are designed as zero-potential relay contacts.

■ 2 x changeover contacts (channel 1 and 2)

■ 4 x NO contacts (channel 3 to 6)

The channels 3/4 and 5/6 are separately

switchable to changeover function. For this,

an external bridge at the terminals is needed.

To protect the module rack, the contact circuits inside the DO60R-N module are shielded by fuses (1.5 AT Ceramic). The module

must be replaced after tripping the fuses. The

connections 12-13 and 22-23 are not further

protected and should maximally be loaded

with the switching current of a relay contact.

Use preferably terminal 12 resp. 22 for connection.

For non-destructive operation, even in the

event of a short circuit, a back-up fuse with a

fuse integral <2.1A²s must be used (e.g. ESKA 522.714).

Status and error messages of the single outputs and the module are indicated via LEDs

on the fro

■ Relay output for higher switching capacity

■ NO/NC configurable output

■ Configurable as 4 x changeover contact

■ Configurable as 6 x NO contact