601-CS-D-P1工业自动化与控制的监控器-继电器输出规格书PDF中文资料

601-CS-D-P1属于工业自动化与控制的监控器-继电器输出。由力特公司制造生产的601-CS-D-P1监控器 - 继电器输出继电器输出监控器检测工业继电器的异常输出，并触发逻辑输出或触头组。常见的检测类型包括：AC 和 DC 电流或电压、电压不对称、接地故障、温度监控、缺相，以及相位序列或不平衡。这些器件可根据跳闸范围、延迟时间、供电电压、安装类型和开关电路进行选择。

描述 Description

The 601-CS-D-P1 3-phase power monitor is a fully programmable

electronic power monitor designed to monitor 3-phase systems.

The 601-CS-D-P1 has a single relay that can be configured as

a general purpose network output or to trip on ground faults.

The 601-CS-D-P1 monitors ground fault current, phase currents,

phase voltages, power factor and frequency. The RS485MS-2W

communications module allows the 601-CS-D-P1 to communicate

using the Modbus RTU protocol. The Modbus connection can be

used to monitor power parameters, setup the device or control

the fault relay. A DeviceNet™ communications I/O module

(CIO-601CS-DN-P1) is available as well. This CIO module only

works with the 601-CS-D-P1 unit. It is used for sending the

information from the 601-CS-D-P1 over a DeviceNet™ network.

It also provides I/O capabilities and the ability to set the

parameters of the 601-CS-D-P1.

Note: This product must be used with an external Zero-Sequence CT for proper operation

(not included).

FEATURES BENEFITS

Built-in display

Visual indication for programming and viewing

real-time parameters for nominal voltage, voltage

unbalance, current, current unbalance, ground

fault warning, ground fault trip, and ground fault

motor acceleration

15 Programmable

parameters to control

the device operation

Allows the user to customize the protection required

for their system

2 programmable trip

delay timers

Program separate trip delay time for motor

acceleration and ground fault

Network

communications

capability

Compatible with Modbus RTU and DeviceNet™

protocols with the use of separate

communications module