XL9535D中文资料信路达数据手册PDF规格书

DESCRIPTION

This device (XL9535/XL9555) is a 24-pin CMOS IC that provides 16-bit of General Purpose parallel

Input/Output (GPIO) expansion for most micro-controller families via the I2C-bus/SMBus interface

[serial clock line (SCL), serial data line (SDA)]. These device is designed for 2.3-V to 5.5-V VCC

operation. The improvements include higher drive capability, 5 V I/O tolerance, lower supply

current, individual I/O configuration, and smaller packaging. I/O expanders provide a simple

solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans,

etc.

These device consists of two 8-bit Configuration (Input or Output selection); Input Port, Output Port

and Polarity Inversion (active-HIGH or active-LOW operation) registers. At power on, the I/Os are

configured as inputs. The system master can enable the I/Os as either inputs or outputs by writing

to the I/O configuration bits. The data for each Input or Output is kept in the corresponding Input or

Output register. The polarity of the Input Port register can be inverted with the Polarity Inversion

register. All registers can be read by the system master.

These device open-drain interrupt (INT) output is activated when any input state differs from its

corresponding Input Port register state and is used to indicate to the system master that an input

state has changed. The system master can reset these device in the event of a timeout or other

improper operation by utilizing the power-on reset feature. The power-on reset sets the registers to

their default values and initializes the I2C/SMBus state machine. Three hardware address pins (A0,

A1 and A2) vary the fixed I2C-bus address and allow up to eight devices to share the same

I

2C-bus/SMBus.

FEATURES

l I

2C-bus to 16-bit GPIO expander

l Operating power supply voltage range of

2.3-V to 5.5-V

l Low standby current consumption

l 5 V tolerant I/O ports

l 400 kHz fast-mode I2C-bus clock

frequency

l Noise filter on SCL/SDA inputs

l Internal power-on reset

l No glitch on power-up

l Polarity Inversion register

l Address by 3 hardware address pins for

use of up to 8 devices

l Open-drain active LOW interrupt output

l 16 I/O pins which default to 16 inputs

l Latch-up testing exceeds 100 mA per JESD

78

l ESD protection exceeds JESD 22

2000 V HBM, 200 V MM and 1000 V CDM