X-NUCLEO-IKS01A2开发板套件编程器的评估板-扩展板子卡规格书PDF中文资料

X-NUCLEO-IKS01A2属于开发板套件编程器的评估板-扩展板子卡。由意法半导体集团制造生产的X-NUCLEO-IKS01A2评估板 - 扩展板，子卡评估和扩展板及子卡用于向微控制器平台添加功能，它们可以堆叠到现有针座或预配置的附件端口上。常见功能类型包括放大器、雾化器、音频、时钟定时、接口连接性、数据获取/记录、显示、人机界面、存储器、电机驱动器、光电器件、电源管理、原型设计、继电器和晶体管、RF 和传感器阵列。

特性 Features

• Equipped with Arduino UNO R3 connectors and compatible with STEVALIOD003V1,

X-NUCLEO-IKS01A2 and NUCLEO-L073RZ boards.

• The STEVAL-IOD003V1 features:

– IO-Link (PHY) device layer based on L6362A

– Operating voltage range 6.5 to 35 V

– Dedicated CQ overload pin (wake-up)

– Diagnostics pin (UVLO, overtemperature and cut-off)

– UART interface

– Linear regulators for independent supply from +24 V bus (12 mA 3.3 V and

100 mA 12 V)

– LEDs for status and diagnostics

– Overload and overheating protections with non-dissipative cut-off function

– Full reverse polarity on IO-Link interface pins

– EMC protections according to IO-Link v1.1 and IEC 60947-5-2

– Ground and VCC wire break protections

• The X-NUCLEO-IKS01A2 features:

– LSM6DSL 3D accelerometer and 3D gyroscope

– LSM303AGR 3D accelerometer and 3D magnetometer

– LPS22HB pressure sensor

– HTS221 capacitive digital relative humidity and temperature

– DIL24 socket for additional MEMS adapters and other sensors

– Free comprehensive development firmware library and samples for all

sensors compatible with STM32Cube firmware

• The NUCLEO-L073RZ features:

– STM32L073RZT6 32-bit microcontroller based on ARM® Cortex®-M0+ core

– Pre-programmed IO-Link device stack (v1.1 compatible)

– Arduino UNO R3 connectivity and ST morpho extension pin headers

– Mbed-enabled (http://mbed.org)

– On-board ST-LINK/V2-1 debugger/programmer with SWD connector

描述 Description

The P-NUCLEO-IOD01A1 is an STM32 Nucleo pack composed of the NUCLEOL073RZ

development board, the STEVAL-IOD003V1 evaluation board and the XNUCLEO-

IKS01A2 expansion board.

The STEVAL-IOD003V1 offers an IO-Link device PHY layer (L6362A) while the

NUCLEO-L073RZ runs an IO-Link demo stack (developed by and property of

TEConcept Gmbh) compatible with rev 1.1 and firmware controlling the X-NUCLEOIKS01A2

sensors.

The STM32 Nucleo pack provides an affordable and easy-to-use solution for the

development of IO-Link and SIO applications, L6362A communication features and

robustness, together with the STM32L073RZT6 computation performance.