VPS2535H中文资料支持模拟电流感应的双通道高侧驱动器数据手册ST规格书

描述 Description

The VPS2535H is a monolithic device made using STMicroelectronics® VIPower® technology, intended for driving resistive or inductive loads with one side connected to ground. Active VCC pin voltage clamp protects the device against low energy spikes.

The device integrates an analog current sense which delivers a current proportional to the load current.

Fault conditions such as overload, overtemperature or short to VCC are reported via the current sense pin.

Output current limitation protects the device in overload conditions. The device latches off in case of overload or thermal shutdown.

The device is reset by a low level pass on the fault reset standby pin.

A permanent low level on the inputs and on the fault reset standby pins disables all outputs and sets the device in standby mode.

特性 Features

• General
•Very low standby current
•3.0 V CMOS compatible input
•Optimized electromagnetic emission
•Very low electromagnetic susceptibility
•Fault reset standby pin (FR_Stby)
• Diagnostic functions
•Proportional load current sense
•High current sense precision for wide range currents
•Off-state open load detection
•Output short to VCC detection
•Overload and short to ground latch off
•Thermal shutdown latch-off
•Very low current sense leakage
• Protections
•Undervoltage shutdown
•Overvoltage clamp
•Load current limitation
•Self limiting of fast thermal transients
•Protection against loss of ground and loss of VCC
•Thermal shutdown
•Electrostatic discharge protection