V62SLASH03609-01XE中文资料德州仪器数据手册PDF规格书

features

Controlled Baseline

− One Assembly/Test Site, One Fabrication

Site

Extended Temperature Performance of

−55°C to 125°C

Enhanced Diminishing Manufacturing

Sources (DMS) Support

Enhanced Product Change Notification

Qualification Pedigree†

High-Speed 6 MSPS ADC

4 Single-Ended or 2 Differential Inputs

Simultaneous Sampling of 4 Single-Ended

Signals or 2 Differential Signals or

Combination of Both

Differential Nonlinearity Error: ±1 LSB

Integral Nonlinearity Error: ±1.8 LSB

Signal-to-Noise and Distortion Ratio: 68 dB

at fI = 2 MHz

Auto-Scan Mode for 2, 3, or 4 Inputs

3-V or 5-V Digital Interface Compatible

Low Power: 216 mW Max

5-V Analog Single Supply Operation

Internal Voltage References . . . 50 PPM/°C

and ±5% Accuracy

Glueless DSP Interface

Parallel μC/DSP Interface

Integrated FIFO

Available in TSSOP Package

applications

Radar Applications

Communications

Control Applications

High-Speed DSP Front-End

Selected Military Applications

description

The THS1206 is a CMOS, low-power, 12-bit,

6 MSPS analog-to-digital converter (ADC). The

speed, resolution, bandwidth, and single-supply

operation are suited for applications in radar,

imaging, high-speed acquisition, and communications. A multistage pipelined architecture with output error

correction logic provides for no missing codes over the full operating temperature range. Internal control

registers are used to program the ADC into the desired mode. The THS1206 consists of four analog inputs,

which are sampled simultaneously. These inputs can be selected individually and configured to single-ended

or differential inputs. An integrated 16 word deep FIFO allows the storage of data in order to take the load off

of the processor connected to the ADC. Internal reference voltages for the ADC (1.5 V and 3.5 V) are provided.

An external reference can also be chosen to suit the dc accuracy and temperature drift requirements of the

application. Two different conversion modes can be selected. In single conversion mode, a single and

simultaneous conversion of up to four inputs can be initiated by using the single conversion start signal

(CONVST). The conversion clock in single conversion mode is generated internally using a clock oscillator

circuit. In continuous conversion mode, an external clock signal is applied to the CONV_CLK input of the

THS1206. The internal clock oscillator is switched off in continuous conversion mode.