UCD9220中文资料2MHz、2 轨、四相数字 PWM 降压控制器数据手册TI规格书

描述 Description

The UCD9220 is a multi-rail, multi-phase synchronous buck digital PWM controller designed for non-isolated DC/DC power applications. This device integrates dedicated circuitry for DC/DC loop management with flash memory and a serial interface to support configuration, monitoring and management. The UCD9220 was designed to provide a wide variety of desirable features for non-isolated DC/DC converter applications while minimizing the total system component count by reducing external circuits. The solution integrates multi-loop management with sequencing, margining, tracking and intelligent phase management to optimize for total system efficiency. Additionally, loop compensation and calibration are supported without the need to add external components. To facilitate configuring the device, the Texas Instruments Fusion Digital Power™ Designer is provided. This PC based Graphical User Interface offers an intuitive interface to the device. This tool allows the design engineer to configure the system operating parameters for the application, store the configuration to on-chip non-volatile memory and observe both frequency domain and time domain simulations for each of the power stage outputs. TI has also developed multiple complementary power stage solutions - from discrete drives in the UCD7k family to fully tested power train modules in the PTD family. These solutions have been developed to complement the UCD9k family of system power controllers.

特性 Features

• Fully Configurable Multi-Output and Multi-Phase Non-Isolated DC/DC PWM Controller
• Supports Switching Frequencies Up to 2MHz With 250 ps Duty-Cycle Resolution
• Hardware-Accelerated, 3-Pole/3-Zero Compensator With Non-Linear Gain for Improved Transient Performance
• Supports Voltage Tracking, Margining and Sequencing
• Supports Phase Adding/Shedding for Multi-Phase Power Stages
• 12-Bit Digital Monitoring of Power Supply Parameters Including:
• Output Current and Voltage
• Multiple Levels of Overcurrent Fault Protection:
• Analog Comparators Monitor Current Sense Voltage
• Over and Undervoltage Fault Protection
• Enhanced Nonvolatile Memory With Error Correction Code (ECC)
• Supported by Fusion Digital Power™ Designer, a Full Featured PC Based Design Tool to Simulate, Configure, and Monitor Power Supply Performance.
• Industrial/ATE
• Telecommunications Equipment
• Storage Systems
• FPGA, DSP and Memory Power

Fusion Digital Power, Auto-ID are trademarks of Texas Instruments.