UC3856数据手册集成电路（IC）的PMIC-稳压器-DCDC开关式控制器规格书PDF

描述 Description

The UTC UC3856 is a high performance current mode PWMcontroller ideally suited for low standby power. An externallyJFET’s gate pin is connected the ST pin, It can achieve HV start,and when start was overed, it is no long consume current todepress the power off. Low VDD startup current make the powerreliable on startup design and a large value resistor could be usedin the startup circuit to minimize the standby power. At no loadcondition, the IC operates in power-saving mode for lower standbypower, decreasing frequency for Higher conversion efficiency atlight load condition.The UTC UC3856 contains protection with automatic recoveryincluding OLP (over load protection), OTP (over temperatureprotection), OVP (over voltage protection), UVLO (VDD over voltageclamp and under voltage lockout).To protectthe power MOSFET, Gate-drive output is fixed up to 15V max. The UTCUC3856 contains protection OCP (cycle-by-cycle current limiting).The internal slope compensation improves system stability at high PWMduty cycle output. Leading-edge blanking on current sense input removesthe signal glitch, which offering minimal external component count in thedesign. Excellent EMI performance is achieved with UTC proprietary frequency hopping technique (ZL201020615247.1) together with soft driver control. Audio noise is eliminated due to switch frequency more than 20kHz during operation.The UTC UC3856 has such applications as: battery charger, power adaptor,set-top box power supplies, ink jet printers, open-frame SMPS.

特性 Features

• UTC proprietary frequency hopping technology for Improved EMI performance.
• Power-saving mode for high light-load and standby efficiency
• Dynamic peak current limiting for constant output power
• Built-in synchronized slope compensation
• OTP,OLP,OVP and VDD clamp for higher security
• High efficiency HV start
• Gate output voltage clamped at 15V
• Low start-up current
• Cycle-by-cycle current limiting
• Under voltage lockout (UVLO)
• Few external components required