TPT1145NQ-DFKR-S中文资料思瑞浦数据手册PDF规格书

特性 Features

• Meet the ISO 11898-2:2016 and SAE J2284-1 to SAE

J2284-5 Physical Layer Standards

• Supports CAN FD and Data Rating up to 5 Mbps

• Short Propagation Delay Times and Fast Loop Times

• 5-V Power Supply, I/O Voltage Range Supports 2.8-V

to 5.5-V MCU Interface

• Support Partial Networking by Means of Selective

Wake Up/Wake-Up Frame with INH Output

• SPI for Device Configuration and Status Retrieving

• Ideal Passive Behavior to CAN Bus when Unpowered

• Common-Mode Input Voltage: ±30 V

• Protection Feature:

– IEC 61000-4-2 ESD Protection up to ±10 kV

– Bus Fault Protection: ±70 V

– VCC Undervoltage Protection

– TXD Dominant Time-Out Function and BusDominant Time-Out Function

– Thermal Shutdown Protection

• Available in SOP14 Package and Leadless

DFN4.5X3-14L Package

• AEC-Q100 Qualified for Automotive Application,

Grade 1

Applications

• All Devices Supporting Highly Loaded CAN Networks

• Automotive and Transportation

– Body Electronics / Lighting

– Power Train / Chassis

– Infotainment / Cluster

– ADAS / Safety

描述 Description

The TPT1145 is a CAN transceiver that meets the

ISO11898 high-speed CAN (Controller Area Network)

physical layer standard. The device is designed to be used

in CAN FD networks up to 5 Mbps, with enhanced timing

margin and higher data rates in long and highly loaded

networks. As designed, the device features crosswire,

overvoltage, and loss of ground protection from −70 V

to +70 V, over-temperature shutdown, and a −30-V to

+30-V common-mode input voltage range. The TPT1145

has a secondary power supply input for I/O level shifting

the input pin thresholds and RXD output level. A serial

peripheral interface (SPI) is provided for configuration and

status retrieve. TPT1145 supports selective wake up and

enables the Electronic Control Unit (ECU) to implement

the partial networking function which is operating in an

active state while it is in a low-power sleep mode. The

device comes with the standby mode, which can be waked

up from the CAN bus, and ultra-low power management

controls the ECU in standby and sleep modes, then enable

the power supply by inhibit output through the local or

remote wake-up via wake-up pattern or wake-up frame

identification. TPT1145 includes many protection features

to enhance device and network robustness. There are two

versions of the device, TPT1145Q and TPT1145NQ, the

difference between the two versions is that the Device ID

is different.

TPT1145 is available in SOP14 and DFN4.5X3.0-14L

packages, and is characterized from –40°C to +125°C.